Questions & Answers for: Sony anode

...very careful when removing the high voltage wire that is connected from the HV trippler to the CRT anode. The CRT anode cable stays with the CRT. Good

...off the back thanks [email protected] discharging the tube by putting the screw driver to the anode cap. the driver is connected to the groud of the tube..in order to minimized the electric ...

...that u r using. Its the problem with the battery, when is battery is wipped out the cothode and anode rods in the battery gets weak which causes the battery even not to get charged. if you change ...

...that the circuits of the horizontal section are functioning as specifications mandate) Check the anode voltage on the CRT with a HV probe and do a diagnostic of the CRT with a CRT Test set ...

...here is how I would do it: 1) unplug TV and remove the back panel of the TV set. 2) discharge the anode voltage of the CRT by using a screwdriver attached to a clip lead which is attached to the ...

...do you think the lamp could have gone? You can remove the lamp and look directly to the lamp and Anode. Check to see if the Anode busted or the Glass outside of the lamp if it seem to Cloudy. In ...

tv makes a noise when turned on cold other wise works fine Hello Your TVs anode cap is arcing. The sound you hear will be like "Ishhh", and a fouling smell of Ozone also be there from the top back ...

just moved the tv from old house to new house, it was raining out side. when we plugged we heard something sound like it was frying. the power button blinks. That was EHT flash over and corona ...

when working on a rear projection TV, Does the flyback needs to be discharged same as an CRT? NEITHER usually need to be discharged, the crt's are sealed at the anode area. SD TECH

...20 hours straight I thought a saw a blue small spark flash in the back of the tv? Check its final anode cap for any voltage leakage.  Seek support to any experienced service ...