Questions & Answers for: Nissan abs code 6 3

my abs light is on after I changed my brakes I changed my brakes because the abs was kicking in for some reason unknown and now the light is on and I don't know why 2004 Nissan maxima 3.5 se If the ...

...code stored in your ABS module. It is a good idea to bring it to a shop that has an ABS scanner to determine the problem. They can tell you precisely which wheel sensor is bad or which ABS component ...

300zx 1990 brakes work done rotor pads, fuel check and abs light still on sensor was replaces , what else I can do to get that abs light off ? A component of your abs system is likely bad. It may be ...

...system. What you must do now is have the ABS system module scanned for fault codes, then based on the code or codes the proper diagnostics are done and the problem parts replaced or wiring

...is on abs light is and where is the fuse under the hood the abs light is on that means there have some problems on the abs system. Take a obd2 code scanner to check it.______________FGTech ...

...code 71 as ABS control unit problem. Can anyone help me to find out where the control unit is? It definitely not inside the driver's lower dash side. I guess that the ABS module is with the ...

...out of the ABS control module without a scanner. If so, where is the connector and what pins do you bypass? Need a code reader & may need a professional scan tool, to get all the ...

brakes abs abs light on brakes grabbing intermittently Have the ABS codes pulled, this will give you an idea of what is going on. It sounds like a faulty speed sensor, but check codes 1st.

...code: "the ABS sensor right front wheel". After replacement of ABS sensor the function was OK. After 100 m the ABS warning lamp turned on again. New code: "malfunction in the ABS sensor. my CAR: ...

...CODE ABS/CTS light on , nissan Altima 3.5 03 Hi. Code C1109 is set when the ABS Module power supply voltage is lower than normal. Start by checking the fuses. Then inspect the ABS module. Look for ...