wipers work fine when on but when turned off they go down and them back up to 35 degrees and stay until the next time the are turned on... its the setting at which they are set when they are off, you ...
rod and main bolt torque specs rods bearings for the 4.2 engine is.18 ft lbs +110 degrees. main bearings 18 ft lbs +180 degrees. the 5.3 engine rod bearings torque is.15 ft lbs +85 degrees.main ...
...hi i have a question about car engine, i have a projekt im building and for that i have a stock 130 hp 2 l 4 cylinder engine no mods or tuning done on it its just stock, but if i want to have ...
...are clean and on tight. Any suggestions? just had to replace the fuel pump on my 1999 Saab 9-3 with 130 K after being frustrated with stalling over the past 6 months. Earlier attempts to fix the ...
I AM DOING THE HEAD GASKET ON 1999 SAAB 95 4 CYL I NEED THE TORQUE SPEC ON CYL. HEAD Torque spec Step 1- 44 Ft.Lbs. Step 2- 59 Ft.Lbs. Step 3- Tighten bolts an additional 90 degrees. Here the head ...
What is the timing in degrees for 1992 saab turbo convertable.Thanks. On non turbo's the setting is 14 degrees before top dead center (BTDC) and for turbo's it is 16 degrees BTDC
44 FT LBS.THEN TIGHTEN ADDITIONAL 90 DEGREES FOR MAIN BEARINGS 15 FT LBS TIGHTEN EACH BOAT ADDITIONAL 70 DEGREES ROD BEARINGS 15 FT LB TIGHTEN ADDITIONAL 70 DEGREES. CRANKSHAFT DAMPER BOLTS 130 FT LBS
do I have to put aparticular coolent in my saab 2007 95 A 50/50 mix is good to -34 degrees F. The brand of antifreeze is not important. Propylene Glycol Antifreeze and Engine Coolant
exterior temperature guage does not work on my 2007 saab 9-3 aero. The dash board, instead of showing 76 degrees i.e., shows ---- need to be re calaberating. take to dealer
hesitation when accelerating in hot weather Car runs fine if tempriture below 17 degrees have you checked you egr valve?
Usually answered in minutes!
557 Questions
442 Questions
367 Questions
320 Questions
322 Questions