SOURCE: Two stroke ratio
The standard ratio is 32 to 1. That equals 4 ounces of two stroke oil per gallon of gas.
Top rating Pls.
SOURCE: what fuel do I put in the chain saw ie petrol oil
50:1 =:
1gallon premium fuel to 2.6 ounces of quality 2-cycle engine oil
4 liters premium fuel to 80CCs of quality 2-cycle engine oil.
If you have more questions or need additional help please reply below and I will get back to you. Thank you for using FixYa and Good Luck. HTH
Lou
SOURCE: my gilera stalker (49cc) may need an oil top-up.
There is a max mark on the 2 stroke tank visible through a slot in the fairing.
If you cant see that then fill with NEAT oil (no petrol) to within 2 inches of the top, this will last ages
Ride safe
Bike-Doc
Please mark this as very helpful (if it has been!!)
Testimonial: "very rapid assistance - thanks!"
SOURCE: WHERE DO DO YOU PUT THE 2 STROKE OIL MIX IN A SHERCO SM50
hi i dont know these bikes personally but,they will have a seperate tank for the two stroke oil,you will probably find it behind one of the side covers,do not put it directly into the fuel tank,that will cause all sorts of drama,as the oil(being heavier than the fuel)will sink straight to the bottom of the tank,fill the carb with oil,then you will never get it started,hope this helps...cheers
n This product is powered by a 2-stroke engine and
requires pre-mixed petrol and 2-stroke lubricant . Premix
unleaded petrol and 2-stroke engine lubricant in
a clean container approved for petrol.
n This engine is certified to operate on unleaded petrol
intended for automotive use with an octane rating
of 87 ([R + M] / 2) or higher.
1 Litre + 2 0 ml =
2 Litres + 4 0 ml =
3 Litres + 60 ml = 50:1 (2%)
4 Litres + 80 ml =
5 Litres + 100 ml =
The full operators manual is here:
http://www.screwfix.com/sfd/i/cat/pdfs/89/p4763889.pdf
1,944 views
Usually answered in minutes!
×