20 Most Recent
Sony KLV32S400A 32 in. LCD TV - Page 3 Questions & Answers
We had a power outage
Tries tv unplug,replug it back like about an hour later.For the tv to do a resetting itself back to the factory setting.The tv now should be working again now.If it still have the same problems.The tv power supply board is the causes and the problems.That the board where the power a/c cord plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a whole new refurbish power supply board for the replacement.
My tv power comes on
Hi camadino
,
You need to set the auto standby mode to a long time for e.g. 3 hours or disable it.
Check the settings for standby mode and you would be able to set it accordingly.
You could access the TV's settings via the panel on the TV or via the remote which comes with it.
Hope this helps ...:)
Recently, my KLV32S400A 32 in.
hello,
That T-con Problem. Not only bright or blur, mostly picture like polaroid.
Open the back cover, you will see pcb attached on panel.
Fine label of panel, exp : V315B1-L01.
You can buy it online.
Good luck.
My sony lcd klv32s400a is
This is a protection circuit that prevents the tv from coming on (to stop damage of the components) ....you need to check your voltages off the power supply and make sure they all read well (EX: 24v12v5v etc). Also look for popped capacitors that would make the values lower than need be for the tv to power on properly.
Once you repair the power supply then you may need to replace other components if needed (EX: backlight inverter)! The backlight inverter is what lites the screen for viewing!
I would recommend to repair immedately and stop trying to turn it on over and over...this will futher damage your tv and cost more to repair in the long-term.
Please rate if this helps! :D
My sony tv automatically goes into stand by mode
If the unit is playing normally then goes to stand-by, it could be also caused by the main board and or the ballast boards. If it is caused by the ballast boards, it should give you error code with the red stand-by light blinking 11 or 13 times. If the stand-by light does not blink a code, it is probly the main board.
I hope this helps,
Skyassoc
I NEED CODES FOR MY NEWSTAR NTR-B28Z FOR MY SONY TV
ChatGPT 3.5
User
I need code for newstar ntr b28z for my Sony tv
ChatGPT
Unfortunately, I can't provide specific code for your Sony TV remote without knowing the exact model number. However, you can usually find the code in the user manual of your Sony TV or by contacting Sony customer support. Alternatively, you can try using the auto-search feature on your newstar ntr b28z remote to find the correct code for your Sony TV.
User
need code for newstar ntr b28z
ChatGPT
To find the code for your Sony TV using the Newstar NTR B28Z remote, you can try these general steps:
Turn on your Sony TV.
Press and hold the "TV" button on your Newstar remote until it blinks twice.
Enter the code for Sony TVs. Some common Sony TV codes are: 0000, 0011, 0080, 0111, 1234. If none of these work, you can proceed to the next step.
Press the "Power" button on the Newstar remote. If the TV turns off, the code is correct. If not, try a different code.
Once you've found the correct code, press the "TV" button again to lock it in.
If none of the provided codes work, you might need to consult the manual of your Newstar remote or contact their customer support for assistance.
Not finding what you are looking for?