20 Most Recent Boost Mobile Kyocera Hydro Smartphone - Page 4 Questions & Answers

tell some one to fix it

reinstall firmware, by putting the latest firmware file(go for instructions on internet accrding to your device model) in SD card and have your device restart by special key combination to get you to the menu where you can reinstall your complete system. same problem was with my Huwawei Media pad and solved this way.

• Remove the battery cover from the back side of the cell phone. Remove the battery from its compartment and set it aside.
• Use the screwdriver to remove the Phillips-head screws from the back panel of the cell phone. You may also need to remove the antenna from its retaining slot and remove it from the cell phone if you can
• Separate the back panel of the cell phone from the rest of the cell phone's body. Place the cell phone face up and then remove the cell phone's faceplate from the rest of the cell phone. This should leave the LCD screen, keypad and circuit board completely exposed.
• Tilt the LCD screen downward and then disconnect the LCD screen's ribbon cable from the LCD screen and set the screen aside.
• Repeat this procedure in reverse to replace the LCD screen and reassemble the cell phone.

download and install firmware for your specific model. make sure country and carrier are what you require

Are you able to use it all? Is it turning on? *by the way, I just replaced my Hydro today..Anyway, You need to delete emails, texts and apps, clear up some space. I had to do that several times. Today I got tired of it and bought another kind of phone.

Sounds like your digitizer it fried. Did you get it wet?. If its Less than a year old you can contact the manufacturer and get a replacement if it's not liquid damaged. Or if you can find a Digitizer/Glass combo on Amazon you can replace it pretty easily. Sorry, but it sounds like those are your options.

Pull battery, hold power and volume down button until a screen you never have seen before opens up. follow the instructions on how to use the buttons available to you to reset the phone. Clear cache first, then reset phone. this interface is not touch.

Almost all electronics come with a 1 year warranty. Since this is a manufacturers defect then it would be covered under that warranty. Contact your service provider for a replacement. If they give you the run around then contact Kyocera.

Try this, but this wll also wipe all data from your phone. so back up your stuff first Step 1 Power down the Kyocera Hydro smartphone. If the phone is frozen, pull out the battery, wait a few seconds and reinstall it to ensure the phone is off. Step 2 Press and hold the "Volume Down" button and then hold down the "Power" button. Step 3 Release the buttons after a few seconds when you see the Android System Recovery screen. Step 4 Press the "Volume Down" button to highlight "Wipe Data/Factory Reset" and then press the "Power" button to select it. Step 5 Select "Yes -- Delete All User Data." Step 6 Select "Reboot System Now" to complete the reset.

Have you tried to go into your user settings? A lot of times the email address will be listed there and then you would just need to verify the password. Or if you are able to send emails from that account already, you can just send an email to a friend and ask them what email address it comes from.

i want know where do i entry puk code in my cell phone .can u tell me were do i get this option because my phone is not showing (Enter PUK number)

These videos should help. Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/james_afb6d80676c07427