1994 Mazda 626 "distributor" Questions

We changed spark plugs, wires, distributor cap, distributor button, etc. We unbolted the entire distributor assembly and pulled it out from the engine. We now can't get the car to start or run. How do

...2l I need to replace the cooling system hose which is very near the engine block behind the distributor. To get at it it looks like I need to remove the distributor from its mounting on the ...

...Manual transmission 2.4 1996 Mazda 626. Replaced plugs, wires, rotor and cap. Can see spark at distributor, nothing out the wires. Reolaced distributor with used oart, same outcome. Is ignition ...

I have a mazda 626 1984the plomble is l have received the distributor when I put it back the car dose not want to start Check distributor timing .align your timing Mark to top dead center then see if ...

...speed. i replaced the throttle control sensor and the mass air sensor. i replaced the rotor in the distributor but is still dies. if you throttle up to about 1500 rpm it keeps running. any ideas??? ...

will not start replaced distributor and starter and it's getting fuel When I got in it to leave I put it in gear and it died and never started again it has a manual transmission I replaced the ...

engine firing order 1996 Mazda 626LX also distributor order If is $ Cylinders 1-3-4-2, locate the cylinder Number one on the distributor than spin the motor and look which way the rotor turns follow ...

Car lost all spark. It started once then nothing. Suspect failed distributor. Common problem with these vehicles. Replace complete distributor assembly.

Intermittant flat spot at 3000 + revs under load. 1982 Mazda 626 Check the distributor ,pull the cap,look in,see if there is oil standing in the bottom of the distributor.

...sensor. This means that the fuel and ignition systems performance are in need of attention. 1.Distributor Cap: remove the 3-bolts holding the distriboutr to its body. 2. Inspect the distributor ...