...things to know , tools etc.....? Nothing special about these brakes. Parking brake is behind rotor, so all caliper pistons push into bores. ASE Master Tech with L1 and X1 certs. Chrysler Level 3 ...
...Speed Problems Scan Data for Idle Melisa, your throttle body is probably sticking. Remove fuses #10 and #28 under the hood first for the relearn. Remove throttle body and clean both sides with a ...
...TRY TO FIND THE PROBLEM IN ONE SHOT. ITS BEST TO FIND OUT WHATS NOT WRONG THIS WAY YOU DONT HAVE 10 DIFFERANT PEOPLE TELLING YOU TO TROW PARTS AT IT. remember, your freind may have had a problem ...
...bored 030 over with 10-1 comp high dome pistons, slight agressive cam 118 cc heads. any solutions for mis fire after 2 hours of run time??? Running on a stand is not the same as running under ...
things out but everything seemed OK. After about 10 mi the engine started to lose power so we stopped again and shut the engine. It seemed OK to the touch so we started it for a minute. The heater was
Question about Nissan Murano
...10-14 Nm). Primary timing chain slack, eliminate it by placing a wedge between the primary timing chain tensioner and the guide shoe Secondary timing chain, tension it by applying counterclockwise ...
...not rebuild-able. U will need a cylinder hone to do this, available at any parts store for about $10 I HAVE A 1993 240SX SE, AND THAT CLUTCH LIQUID WILL MESS UP YOUR CARPET.YES YOU CAN REPLACE THE ...
Question about Cars & Trucks
...10 may fire using factory Remington loads. This could be a lot of things. It may be a weak hammer spring, it may be the counter bore on the chamber being milled to the wring spec etc. A gunsmith or ...
...seals. And the system seems to be fully sealed. Not seeing any air when bleeding. Went through 7-10 bottles of brake fluid while bleeding, and just cannot fix this problem. you have to pump the ...
...should have the plugs removed, and each cylinder should have atleast 150 psi, with no more than a 10% difference between the 8 cyl . most engines period will cary atleast 90 to 180 psi depending on ...
504 questions posted
Usually answered in minutes!
323 Questions
310 Questions
201 Questions
129 Questions
107 Questions