2002 Nissan Altima "int bank" Questions

Ad

int/v tim cont b1 DTC P1212 - Mass Air Flow Circuit Intermittent Low DTC P0011 - "A" Camshaft Position - Timing Over-Advanced or System Performance (Bank 1)A P0011 DTC trouble code

Ad

...bank 1 and clean and make sure its not stuck or replace it with a new one and this should fix your problem. Altima 2013 p0011 and sometimes a p0300 Thought like most its stalling must be the timing ...

Ad

...int/v on bank one is -1CA while bank 2 reads at 4CA and eng speed is around 160 rpms while cranking. no dtc's are stored. security light works as should. compression was low on bank 2, added oil ...

Question about Nissan Altima

1 Answer

...bank 1 is the head that is the farthest forward on eng. (pass. side) and intake sensor would be the inner sensor....there are 4 of them...2 exhaust and 2 intake . each head has 1 exh. and 1 int. ...

...bank 2 "upstream" oxygen sensor. The oxygen sensor alerts your system when the condition is too rich meaning there's too much fuel int the exhaust stream or too little oxygen in the exhaust stream. ...

bank 1 circuit malfunction. Where might this be located and how to replace it? Also got a code P0601 INT control module memory check sum error. Any recommendations would be appreciated greatly. Thanks

...Bank 1 (INT/V TIM B1) is 64 Degrees CA. We replaced the rear and that didn't fix it, the car will start and you can rev it up but that "64" number NEVER changes. Bank 2 is reading anywhere from 0-2 ...

Question about Nissan Altima

1 Answer

...bank 1 to lean). It set the mil lamp and then reset it self. Pulled the code with a scanner and found 1 of 2 to be P2096 and 2of 2 to be P2096 Pd. The description of the dtc os coming from my scanner ...

Question about Nissan Altima

3 Answers

...bank 1. High knocking noise at 2500 RPM and knocking noise at idle. Engine oil constantly checked and filled. *May have been driven while out of oil once without knowledge* sounds like the shells int ...

Question about Cars & Trucks

1 Answer

...Int valve solenoid sensor instead it throws a p1111??? code p 1110 refers to the valve timing control solenoid and not the cam position sensor replace or repair that unit code p 1111 refers to the ...

Not finding what you are looking for?
2002 Nissan Altima Logo

2,096 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2005 Nissan Altima
2005 Nissan Altima

1,587 Questions

2003 Nissan Altima
2003 Nissan Altima

1,450 Questions

2001 Nissan Altima
2001 Nissan Altima

569 Questions

1995 Nissan Altima
1995 Nissan Altima

534 Questions

1994 Nissan Altima
1994 Nissan Altima

410 Questions

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...