Intel Motherboard "jumper settings hard drives" Questions

Ad

Question about Gigabyte Computers & Internet

1 Answer

...jumper settings on the drives are correct (1 master and 1 slave) when placing 2 drives on the same channel for example. Most likely your jumper settings are not correct and are causing this problem. ...

Ad

Question about AOpen Computers & Internet

2 Answers

...hard drive. jumper positions on the hard drive are usually labelled on the top of the drive, but this will not prevent it spinning up. You have either a bad IDE cable ( try replacing it), or more ...

Ad

Question about Computers & Internet

1 Answer

...of the HDD seen by PC BIOS on some older hard disks. Usually settings which are selected by jumper setting to various locations are printed on the hard disk information sticker. hope this ...

Question about AOpen Computers & Internet

1 Answer

...jumper settings may not be correctly set. If there are now two IDE drives both the primary master & secondary drive's jumpers must be set correctly. You will ned to look at the white sticker on the ...

Question about Computers & Internet

2 Answers

jumper settings verify this link http://h10025.www1.hp.com/ewfrf/wc/document?docname=bph03792&lc=en&dlc=en&cc=us&product=3872037 YOu have to set jumper settings on harddisk and cd rom.

Question about VIA Computers & Internet

3 Answers

...Hard Drive jumper pins. Check you HD data for the proper setting. plz chek your data cable of sata hdd. and then open bios setup and go advance option and check ther hdd is ditect or not if not then ...

Question about Computers & Internet

1 Answer

...Jumper pins on the Drives! Secondary= One drive must be set as Master, The other as Slave. That Should do it. Go into your bios setup screen, go to the boot configuration and set it up so that your ...

Question about ASUS Computers & Internet

2 Answers

...settings. The IDE devices can be connected on the same ribbon cable but need to have jumpers set on the back to determine which device is primary or slave. If the IDE devices are on different ribbon ...

Question about Dell Computers & Internet

1 Answer

...with A seperate Cable. Or Add it to The Hard-Drived Cable. If The Hard-Disk Is Jumper-Set as Slave, Move Jumper-Pin ( Small Plastic Block ) on the rear Of The Drive To Master. Mike @

hard drives. Your motherboard should have two IDE channels, labeled IDE 1 and IDE 2, Primary IDE and Secondary IDE, or something similar. Each IDE channel can support two devices. For best performance

Not finding what you are looking for?
Intel Motherboard Logo

5,393 questions posted

Ask a Question

Usually answered in minutes!

Top Intel Computers & Internet Experts

Brad Brown

Level 3 Expert

19187 Answers

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

SmartAviator
SmartAviator

Level 3 Expert

1124 Answers

Are you an Intel Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...