Need to know how to replace my front brakes pads on 1993 Nissan Pathfinder two wheel drive?

SOURCE: hand brake nissan pathfinder

If you lift the hand brake you should find an adjustment nut (I think it is 10MM). Tighten that and you should be good to go. Be careful, it doesn't take much to adjust - turn gradually/slowly.

i hope i was able to help you with your problem! tc!

SOURCE: how do i replace the starter in a 1993 nissan pathfinder?

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528018d0be

SOURCE: 1999 nissan quest brake pad replacement

Remove wheel & tire,
remove 2 torx bolts that go from the inside to the outside of the vehicle. They are on the inner side of the brake caliper.
lift the caliper out of the rotor.
remove the brake pads.
To install, you must first squeeze the caliper piston back inot its bore. Do this slowly to prevent damage to the piston. You are forcing excess brake fluid back into the master cylinder reservoir. Slow constant pressure will get the job done. Use a large c clamp or a wooden hammer handel if that's all you have.
Fit the new brake pads in the calipers and slide the assembly back over the rotor.
install the 2 torx bolts, size 40? head I think.
You are done.
If rotors are scored bad, replace them too.

SOURCE: replacing front brake pads on 2002 Nissan Altima

It would be to hard to tell and show you over the computer.
The best and easiest way for you is to buy a Chilton manual for your car at the autoparts store. The book runs about $20
This book is a do-it-yourself bible. It will show you everything you need to know on how to do maintenance and repair on your vehicle.

SOURCE: 99 nissan pathfinder 4 wheel drive once put into 4 wheel drive popping noise underneath the vehicle

my 98 pathfinder has a 2h,4h,n,4L on the all wheel drive shift,but the shift only allows me to put it in 4Low,what im a supposed to do to put the gear in 2h or 4h?