I am trying to charge battery in my s 70 volvo glt 1999 is it 6 or 12 volt setting?
SOURCE: 1999 volvo radio code
To reset the radio you have to leave the key in position one (the radio will come on, but the dash lights are not on) with the radio on for at least two hours. It can take up to four hours to reset.
Make sure the climate control and blower are in the off position to keep the battery from running down. Eventually the radio will say "code". There is a four digit code that is unique to each radio, if you don't have it you must contact the local Volvo dealer and have your VIN code. The VIN code is locate on the far top/right side of the dash, you must be outside the car to see it. It will begin with something like YV1LS...................
When you get this code from the dealer you input the code using the radio preset (1-6 buttons). If the radio says code again that means it is the incorrect radio code. Most likely the radio has been replaced. Then it would be alot easier to take it to the dealer since the radio has to be removed and the serial number taken off the radio chassis unit. Usually most dealers will do it for free if they think you'll come back for services, so just tell them you just bought it and be nice, hopefully it will work.
hope this helps
SOURCE: need plastic seal at nozzle end of fuel injector
That was there for assembly purposes, I have ordered new injectors, and they have not been on there either. There is no actual need for that lower plastic retainer, and its NOT available through the dealer either
SOURCE: volvo s70 glt po456 442 301
I believe the PO456,PO442 are evap conserns The PO301 is a miss fire on cylinder #1
SOURCE: how to reset service light on 1998 volvo s70 glt
Hi the 1998 Volvo Have OBD II and require a code reader to to read and erase code which resets the service engine soon light if you go to AutoZone they will reset it for you for free.
Have a good night.
SOURCE: 1999 volvo s70 glt where is the throttle position sensor located on the motor
It is going to be on the throttle body,it will be a rotational type sensor,so it will be inline with the throttle plate shaft.
184 views
Usually answered in minutes!
×