99 Saturn SC2 person was installing radio, car was starting fine as we kept turning key to see if radio worked. never got radio to work and found 3 fuses blown non of which had to do with ignition..... So now car wont start, replaced battery, disconnect shut off gadget from car dealer and re-connected wires to ignition switch.......... "still wont start" We have power to all dash lights, head lights and every thing else when key is turned start position.... however seems as if nothing is going to starter or something???? So now were told we may need to replace starter??? I felt it may be the iginition switch because it could just be the on tab which sends power to starter is fried??? ANYONE GOT AN ANSWER OR SUGGESTION PLEASE
SOURCE: saturn sc2 wont start
You most likely have a burnt terminal in your Inside fuse block.Easiest way to check this is to remove the console trim panel next to the drivers side front of console,just pulls loose.Then while trying to start the engine reach down & wiggle the wring going into the front 68way connector.If it takes off & starts to crank you have a burnt terminal in the fuse block.If you remove the front connector (68 Way) there are 2 of these 68 ways in that block.You can look inside at the male terminals you will see one terminal with plastic melted around it.If you see this,that''s your problem!! You will need to find a used Fuse block at junkyard with same Part #.Very important to get same part!! Hope This helps
214 views
Usually answered in minutes!
×