20 Most Recent 2006 Toyota Corolla - Page 4 Questions & Answers

I think that is the main fuse for the alternator, which when blown prevents battery charging.

You can't do what your trying to do. follow procedure in the book for best results.

Replacement parts should simply replace original parts.

Corollo

53 second row left seatbelt sensor (subfault) 43 third row left frontal stage 3 deployment control (subfault) 32 second row left frontal stage 2 deployment control (subfault) Yes parts related seatbelt sensor and a collision sensor. Two questions has this car been in a collision, did the airbags deployed, is the seatbelt not retracting. This is a serious problem if you have a collision there will be no protection

Check exhaust system. It seems to be clogged.

Hello, the idle speed is controlled by the computer, there is no adjustment, what you can do is to clean the inside of the throttle body: Remove the intake hose from the T/Body, disconnect the battery, use a can of air intake/throttle body cleaner and a brush, open the throttle all the way and clean the carbon out, put the hose back and reconnect the battery, start the engine and keep the rpm up until it clears out, drive it for about 15 minutes, about 90% of the time this fixes low idle.

My Ford had a modulator valve that malfunctioned and it caused the transmission oil to be burnt and smoked through the exhaust. Once the modulator valve was change I had no problem. Am not sure if your car has one.

a lot of things you need to get code then go from there

code is wrong, missing last number. sorry post all codes using a real scan tool, never just one if many there. no engine size stated, so cant help. the engine is probably misfiring and there are 50 causes what us to gue$$ or show TESTS. her is my useless guess. never tuned up this decade? (9years)

have a look on this web page Generic OBD II Chassis Codes

air bags get the bags scanned, read the FSM on bags yet< (factory service manual) or at alldata.com, DIY. in what country? , did you read the TSB recall yet>????? huge recall. where is this 31 code? at>? Trouble Code: B1000/31 (1.8L L4 VIN R Auto) Airbag ECU Malfunction * Airbag sensor assy center remove battery neg lug before touching any SRS parts. B1000/31; Center Airbag Sensor Assembly Malfunction (2006 Corolla From 07/2005) DESCRIPTION The center airbag sensor assembly consists of a deceleration sensor, safing sensor, drive circuit, diagnosis circuit, ignition control, etc. If the center airbag sensor assembly receives signals from the deceleration sensor, it determines whether or not the SRS should be activated. DTC B1000/31 is recorded when a malfunction is detected in the center airbag sensor assembly. If only DTC B1000/31 is output, do not clear the DTCs, replace the center airbag sensor assembly. If any DTCs other than DTC B1000/31 are also output, troubleshoot those DTCs first. use a real scan tool and see all errors. if not you guess wrong.

DTC 31 Is a vacuum sensor (MAP) signal/vacuum sensor or circuit,Electronic control module malfunction (ECM,PCM)

An auto parts store will be able to look that up for you.

It sounds you have a short or an internal problem in radio I would by an after market radio with antenna kit and harness kit

Change the ECU to the 1800

The settings would be completely different - you will need the 1.8 ECU

There is a mode door in those that controls where the air comes out and there is a blend door that controls the temp of the air. If you cant change from hot to cold then the problem is the blend door. You should be able to see it behind the glove box. The glove box door has stoppers on it that you can remove so that it drops out of the way, then you can see the plenum that holds the heater core and the fan. There is also a filter in the plenum for in cabin air filtration. Change the temp settings and see if any of the levers on the plenum move. If they move then the blend door is either loose or broken off inside the plenum.

??? what