20 Most Recent 2004 Pontiac Aztek - Page 3 Questions & Answers

Seems to be a broken solenoid relay which is mounted to the starter motor (should engage the starter) - replace the assembly Amazon com AC Delco and 12 Volt Starters Starters Parts Automotive

seems to be a broken solenoid relay which is mounted to the starter motor (should engage the starter) -replace it Amazon com 50 to 100 AC Delco and 12 Volt Starters Starters Parts...

Could be a fuse.Are the front parking lights working ?

you don't say where the noise is. that is important to give a clue where the issue is. when stopping on the brakes 3 things happen. you press the pedal and the abs pump starts pumping fluid. the second is the brake capilers start pushing on the rotors to slow the car. the rotors are attached to the wheels and that stops the car. so if the rotors are warped you will feel a vibration in the steering wheel when stepping on the brakes. if its your foot feeling the pump working that is normal for abs pumping. you should feel it and holding the pedal will keep it working and stop you from skidding if everything is working correctly

check see if your engine is getting wet near the cylinder if so u got the intake gasket leaking coolant with majority of it going in the oil, also u should replace thermostat

remove the current fluid, and put in new.

Could be the brake light switch, or the shift lock solenoid. You should be able to shift out of park by turning the key to the unlock position but not to "on". Make sure parking brake is set and crank in neutral.

not sure. my 2000 chevy pickup. has two long rods on the back I have to pull up and the light assembly pulls forward to get to the lights. then its just turn and pull the bulb and replace. make sure you do not get any finger prints on the new bulbs. the oil will burn the bulb up faster and you will be replacing them a lot more often

as you checked already fuses, relays and bulbs there must be something wrong with the light switch in the dashboard. - either a loose connector or worn out contacts. first remove the switch and spray some WD-40 or similar contact spray into the connector from behind - if that does not help you have to replace the light switch with a new one...

There are several places to look but here is a good one. Pontiac results under Recalls TSBs AutoMD

A good scan tool will normally tell which wheel is bad.

If it's really cold where you are located, it could be fuel line freeze up. I always make sure I have a full tank of gas when it's cold. If you are low on gas, add a can of Heat and fill it up with gas.

It is under the right side of the dash .need to remove insulator panel. by my picture five push pins hold it in place. This video will give an idea what's up. How To Install Replace Heat Fan or Blower Motor Chevy Venture Pontiac... what's with yours ?Not working? check for power at the plug for the blower motor. And make sure the power wire is not burnt . If not working at all could have bad blower motor resistor module , very common problem. Blower Motor and Resistor Diagnostics by Wells

Hi! Matt, Most likely if the anti-lock brake light and the awd disable light come on at the same time a wheel bearing / wheel speed sensor assembly is faulty.Listen for a humming noise when driving and try to determine where it is coming from(left/right/front/ back) or any looseness/play in any wheel. That's the possible bearing/wheel speed sensor causing the problem. Or have the abs system scanned to determine which wheel sensor is reading incorrectly.If the awd disable light is off then the awd system should be funtioning.

It could be a wheel bearing as the speed sensor for the abs is located in the bearing