Fisher Paykel Refrigerators - Recent Questions, Troubleshooting & Support

check the thermostat setting for the compartment it may not be set low enough so the alarm goes off when the compartment temperature reaches or exceeds that setting some fridges have a system whereby if the door is open too long then it notifies the user to close the door

Probably not. But you can check it with an ohm meter. If infinate resistance or "open", yes it's bad. If some resistance it should be good. Check with several appliance parts and troubleshooting stores, usually they are quite helpful. They know their parts.

• The Serial number starts with three upper case letters then has half a dozen digits. This is normally also labelled as "SERIAL" or "SERIAL NO" on the serial number plate (sometimes called the rating plate)

If you can pull out the fridge and check the valve to be sure it is open all the way. Next, change the water filter if you haven't changed it in the last 2 months. The only other suggestion is to make sure the line didn't get kinked where it feeds into the door (usually right at the hinge).

Hi,It belongs under the Ice tray to the Ice maker. Without it the unit can not detect temperature of the ice tray to cycle or function as needed.I hope this helps. I’m happy to help further over the phone at https://www.6ya.com/expert/gere_bf68e6055dd61249

If there is no cooling at all on the fridge section but the freezer works then it is confirmed that the compressor and gas pressure is OK. Now shut off the fridge and leave it powered off while you clean and check the evaporator for frost. If frost is seen it is a good indication as the compressor is working with sufficient gas within. Now after about 6 hours plug in the fridge to start. Observe cooling to happen in about one hour and ice to from under three hours. Earlier make sure that the thermostat was set to normal mode for freezer and fridge. However if ice forms in the freezer then observe the fridge for about 24 hours for cooling to continue and the fridge to cut off . If not the auto defrost timer, or the thermostat must be checked. Frost formation without defrosting could block the air flow and so shut the air passage to the fridge. Also the blower fan must work and if this is not working then the fan can be faulty. Also a fault on the control unit is a suspect to non functioning of any one of these components. If defrost timer works but frost keeps forming check while the compressor shuts if the heaters are working, check continuity of the heaters. So try this test using a multi-meter on the defrost timer and the thermostat and make your observations so that we come to the solution.

Please check the link below for tips to remove the panels/parts: http://www.espares.co.uk/advice/fridges-and-freezers/a/2

check the condenser coil, is it plugged? If not you may have a refrigerant leak

Mi es de 1hp necesito saber c?mo van los cables de conexi?n el?ctrica al protector termico y el relay

yes it is

Humming is a classic sign that the start / run capacitor for the compressor has failed. Call for service, have it checked for gas and condenser cleaned. ..