Questions & Answers for: changing 30 amp breaker 40

...reading . Sounds like you may need to change breaker out for new at breaker panel, look for 30-40-or 50 amp suggest qualified electrician only or you could have deathly results. Please Rate. ...

Hi, the main breaker connection on my siemens bos becomes loose. I,ve changed it about 2 years ago because of that problem and when I removed the front panel today, It came loose again cutting down on

...30 AMP breaker. The specs for the new stove says it requires a 50 AMP service and a 40 to 50 AMP pigtail. Can you tell me what AMPs it will actually draw and if my existing service will handle it? ...

...30 amp circuit , it trips the breaker after about 15 min ,,,it has 10 gage wiring but it is an older house , the breakers look ancient..should i replace the breaker with a new 30 amp or should it be ...

30 Amp breaker. The unit is on a room thermostat. Once it trips the breaker, I can reset and run for 5 minutes again, the breaker trips. 17 KW, 208/240 ,1PH/3PH . Do I need to change to 40 amp breaker

30 amp breaker. Have already changed breaker wiring going from box to dryer and installed new motor. Check your load/AMP capacity. If you have other electrical appliances on ie. Iron, Heater, toaster,

...30 amp breaker and 10 gauge wire would be fine for this heater. And since it is 220 volt, you will always use a double breaker. That is because 220 volt appliances don't use a ground, but instead use ...

...changing them to electric. Will I need to change the panel put to a 200 amp. Its probably not a bad idea. Thats alot for a 100A panel to handle, a range needs a 50A, a water heater needs 30A, and the ...

be #10-30 amp, #8-40-50 amp, #6-50-60 amp, #4-70-90 amp and #2-95-135 amp. There are other factors, such as derating etc. but if you wanted to increase to 100 amp, I would run #2 thhn. Hope this helps

30 amp curcuit breaker needing to be changed to 40 amp on 2002 FXST On hot days and when my oil temp gets to about 250 my bike will completely shut down. After waiting for a few minutes, it will start