2010 Mercedes-Benz Sprinter Logo

Related Topics:

Posted on Dec 17, 2010

How do i take the headlamp holder out merc sprinter 1998

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that hasĀ over 10 points.

  • Contributor 32 Answers
  • Posted on Dec 17, 2010
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Hot-Shot:

An expert who has answered 20 questions.

Corporal:

An expert that hasĀ over 10 points.

Joined: Dec 17, 2010
Answers
32
Questions
0
Helped
3808
Points
94

First, open the hood of your van. and look for the bolts that hold it in. some may be hidden toward the bottom by the bumper. once unbolted completly, it should come out easily. i hope this helped

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Code errors

this is the many problems with Merc Benz. These guys have their own Coding system so you have to return to them to get it fixed. They sell you the car but they have many 'gotchas' so you are stuck going to them for maintenance. It should be against the law.
try to find a Merc Benz Forum that may know what those codes mean
0helpful
1answer

How to program my 2006 dodge sprinter mercedes FOB MYT3X7259?

To programe a fob to the EZS you need a manufactures green key only available from merc dealer
1helpful
2answers

I need to know where the vin number is stamped on merc sprinter van

Check on front right wheel arch from outside behind the wheel, there is vin no too
3helpful
2answers

Does a ecu from a merc sprinter or ml fit a grand

From 1992-2002 cherokee shares the same ecu.

Feel safe fitting it.

Rate this, please.
9helpful
1answer

Change headlight

  1. Locate the back of the headlamp assembly on either side that you will replace the bulb - You will see 2 rubber gasket seals with the headlamp bulb wires connectors in the middle of them.
  2. For the bulb you want to replace, carefully pry off the rubber gasket seal and disconnect the wire connector.
  3. Carefully locate the metal "locking" wire that is against the back of the bulb assembly and remove it by pushing in the end of the wire and unhooking it from the bulb holder assembly.
  4. Remove the bulb and note the way it was sitting in the holder assembly.
  5. Reinstall new bulb and reverse directions to close up
3helpful
4answers

I have a turbo charged diesel engine no power at take off or at speed in line 5 cyl. merc-benz dodge sprinter van 2.7 l eng.

before replace your turbo as suggested so called try and error mechanics on your cost, you might want to check your turbo resonator, its common problem with dodge sprinters, in europe no resonator fitted on mercedes sprinters
0helpful
1answer

MY HORN DOSE NOT WORK ON MY MERC SPRINTER

That clicking is most likely the horn relay. Sounds like it needs replacing. Could be loose connections on the relay.
1helpful
1answer

Merc 308 sprinter non starter

Which sprinter 308 you have, 308 cdi or 308 D ? but sounds like sucking air, might be air lock
5helpful
1answer

Sprinter gear selector

This is the gear linkages. It is a cable operated system to allow the gear lever to be dash mounted.

They are a common fault. The parts are about £65 from Mercedes (dealer only part) and unless you know what you are doing you can expect about 2 - 3 hours labour charge, though there are no special tools involved.

They average about 60,000 miles, though the replacements tend to be better.
Not finding what you are looking for?

143 views

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...