Zt7000 zero turn. Where can I get a diagram of belt installation?

Here's a video Doris on your belt. How to Replace Craftsman Zero Turn Riding Mower Ground Drive Belt

http://www.partstree.com/parts/toro/mowers-zero-turn-lawn-mower/74631-toro-timecutter-ss-5000-zero-turn-mower-sn-314000001-314999999-2014/belt-and-pulley-assembly/

Give this link a try. Once you have the belt diagram, and the right belt, it has to fit.

https://www.partstree.com/parts/troy-bilt/mowers-zero-turn-lawn-mower/17wfcacp011-troy-bilt-50-mustang-xp-zero-turn-mower-2013/mower-deck/

http://www.husqvarna.com/ddoc/HUSO/HUSO2008_USen/HUSO2008_USen_O0803016_.pdf

http://c.searspartsdirect.com/lis_png/PLDM/P0904080-00014.png

The above links have diagrams of belt routing. Hope this helps..

First buy proper belt... Next note how old belt is warped around the pulleys, take a picture or draw a diagram... Remove all covers off deck pulleys, and guards to expose belt completely... Pull and stretch belt off one of the idler pulleys, once one is off the rest will slide off... Reverse procedure for installation... Note: grease all nipple fittings, bearing and shafts to avoid seizing of bearings or bushings.

Below is the master help link provided to go through belt routing diagram:---Timing belt, drive belt, serpentine belt, accessory belt, fan belt, engine belt routing diagrams for all types of car models?
Click the link below: ----

http://carbeltrouting.blogspot.in/2012/02/timing-beltdrive-beltserpentine.html
----------This will help. Thanks.

http://c.searspartsdirect.com/lis_png/PLDM/P0401364-00011.png

It should be fairly simple,if you remember always put the V of the belt into V pulleys and the back of the belt on flat or idler pulleys. Its fairly easy to figure out. I didn't find a diagram of the belt system that runs the hydraulic pump. I hope this helps some.

Try this one. It may have what you're looking for. Without your model #, I don't know.... http://www.partstree.com/parts/ Click on Cub Cadet then enter you model # on the left.