I need to be able to install my sata drive it pluged in doesnt show in screen huh?

Hmm, sounds faulty, Return to shop?

Windows doesnt like hardware changes. and specially if your useing a 32bit windows it doesnt support more than 3.0-9GB of ram. you need 64bit windows to work on 4GB or more.

poss windows has fallen over you need an operating system check hdd are master and slave master first one from board go to bios set the cdrom as the default 1st boot device put operating system into cd rom should start to load operating system

HELLO, WHAT YOU ARE TO DO IS TO UNPLUGE ALL PLUGED AND TRY RE-PLUGING YOU WILL SEE THE PROBLEM.

Check whether you have installed the SATA Hard Drive driver using a Floppy disk. Some Computers needs SATA Hard Drive Driver before installing the Windows XP. Try using Windows XP SP2 disk.

If its an IDE cable (Flat wide one) ensure the last drive (Operating system) one is plugged in here set to MASTER, with the slave drive connected along this ribbon set to SLAVE.

If SATA cable usually narrow and red plug into any SATA port on the mobo, doesnt matter which order.

did you format the drive? sometimes it won't show up until you format the drive.

dis connect the sata cable that attaches the sata hard drive to the pci card and then format c and re install with all the drivers you require for the pci card as well as motherboard drivers, network card drivers etc and then re attach the sata cable that way you dont get confused between which drives its showing if it manages to display the sata drive at boot up.

blue screen means system error or hardware problem. maybe your sata drive is the problem. try to use another sata drive.

remove the cmos battery and clear the cmos memory using jumper(it presents near cmos battery ,refer manual of motherboard)
restart the pc-now cmos setting screen appearce
save the bios settings usin F10 or refer onscreen
shutt down the pc ,reset the battery and jumper in original place
start the pc
now try
regards
prasanna