I have a Jabra VBT185Z hands free. I am trying to pair it with my LG phone. It is asking me to enter a passcode. I don't have a passcpde. Can you help me?

it auto pairs .
set mobile phone to bluetooth on
finger click on blue tooth and select discover bluetooth devices
you should see mobile phone detect jabra vbt185z
then pin is 0000 if asked
http://uswww03.gnnetcom.com/jabra/verizon/vbt185z/Datasheet_VBT185z.pdf

Hi,

Follow the instructions mentioned below to resolve the issue:

• Charge the headset
• Charge your Jabra VBT185Z until the solid LED turns off
• (approximately 2 hours)
• Turning the headset On and Off
• Press the answer/end button until you see a burst of flashes on the
• indicator light (LED) to turn your headset on or off.

Headset Pairing Readiness Instructions:

1. Fully charge headset for two hours.
2. The headset will automatically go into pairing mode if no device has
been previously paired.
3. Set your mobile phone to 'discover Jabra VBT185Z'.
4. Enter passkey or PIN = 0000 (4 zeros), then press Yes or OK.

For online pairing assistance visit www.verizonwireless.com/bluetooth.

Hope the above steps allows you to resolve the issue. Please revert back for any further clarification.

Regards

Anand

have you tryed all zeros?,i took a jabra to be paired to my phone and the girl put all zeros and it worked.just dont recall how many it was<think between 4 and 6,wont hurt to try each and see if you get it,good luck...

You do need the passcode. It should "auto pair" but the default passkey or pin is 0000 (4 zeros.)

Here is a link to the user manual
http://www.jabra.com/sites/Jabra/GNimages/Products/WirelessHeadset/BT2010/Documents/UM/VBT185z_UM_6198.pdf

Headset Pairing Readiness Instructions:

1. Fully charge headset for two hours.

2. The headset will automatically go into pairing mode if no device has

been previously paired.

3. Set your mobile phone to 'discover Jabra VBT185Z'.
4. Enter passkey or PIN = 0000 (4 zeros), then press Yes or OK.

dw

passcode is 0000 i.e. four times zero

Turn on paring by pressing and holding center (blue button) until LED is solid blue.
Headset goes into pairing mode (unless already paired). Set your phone t "discover Jabra VBT185Z."
Enter PIN, "0000"

Good Luck!

default passcode is usually 0000

Go to ur phones bluetooth settings - activate pair new device - at the same time press and hold the on button on your blue tooth head set for about 10-15 seconds - this will enter the device into pair mode - on your phone - click on pair with new device etc etc, the default access code is either 0000 or 1234

Good Day,

Passcode is "0000"

Hope this helps

My head set had another pin code other than 0000 when I recieved the unit which made it dificult to connect. I learned how to reset it to the default pin of 0000 which allowed me to sync it with my phone. After using it for a month or so my phone requested the pin again.I entered 0000 and once again would not accept the pin. I had to retore the default pin again and it works just fine. Here are the instructions. Plug your vbt185z into the wall charger and while connected press down and hold the center blue button untill the light comes on.(about 30 seconds)Unplug the the ear piece and turn the unit on.Now enter pin 0000 and your phone should accept the pin.