How to open a view quest retro radio 3945 - Cars & Trucks

Internal problem in radio

I just installed an after market radio in my 94 Quest.
The easiest way is to buy a Nissan Quest Radio Wiring Harness for Premium Sound. It will have the complete wire hookups. You can also hook up the blue wire from the new radio to thefactory (I think Blue or Blue/White) wire on the harness. That will turn the factory amp on.Hope this helps ,good luck

Take the "face" off the radio.Look for a small hole on the radio front.Owner's manual should describe it.Stick pen tip or open paper clip into hole. That pushes against something in there and resets the power.Some radios label the hole as reset but you need good eyes.

any brand,you will need a wiring kit and a monting kit for your specific car make and model.

Most common is the speedometer, for you speedometer issue. As for your radio display. If the radio works but has no display, then it's a radio problem not a fuse.

Thanks Jay!

go here for help

http://autos.groups.yahoo.com/group/villagerquest/

need to know what level of radio you have. There are 3.

Try hooking up some different speakers, and see if that's the problem.

SECTION 501-09: Rear View Mirrors 2001 Villager Workshop Manual REMOVAL AND INSTALLATION Mirror —Exterior Rear View Removal

1. Remove the front door trim panel. For additional information, refer to Section 501-05 .

1. Remove the upper speaker.
   1. Disconnect the electrical connector.
   1. Remove the bolts.
   1. Remove the speaker.

1. Position the watershield aside.

1. Remove the exterior rear view mirror access panel.

1. Disconnect the exterior rear view mirror electrical connectors.
   • Release the wiring harness locator.

1. Remove the exterior rear view mirror.
   • Remove the bolts.
   • Feed the wiring harness through the door opening.

http://www.radio-code.com/