I HAVE A GRANDE AM 200O MY QUESTION IS I PUT THE KEY IN THE KEY SWITCH AND I CAN MOVE UP AND DOWN THE KEY TO THE SWITCH CAN ON. I CAN CHANGE THE KEY SWITCH? OR I NEED REPROGRAM THE SECURITY SYSTEM?

You've interrupted the antitheft system. It can't recognize the key signal and shuts down to prevent theft.

http://vatspasslockpasskeysecurityhelp.yolasite.com/

Sounds like it in the key switch. Try to jiggle the key back and fourth to see if it will stop it

This can be a very touchy system. One wrong move on install can damage things down the line. Ive had good luck bypassing these systems. No more smart keys, no more security lights.

http://vatspasslockpasskeysecurityhelp.yolasite.com/

Check/replace the brake light switch on the top of the brake pedal.

coolant come in two versions mixed and unmixed, in unmoixed use half coolant and half water, you can add coolant yourself but do not remove the radiator cap when the engine is hot, its under pressure and dangerous, any good brand coolant will do, then have the system checked for leaks

ur cylinder lock is going bad...... needs to be replaced

The limited edition brings memory setting for mirrors and seats, it recognizes which key are you putting in the ignition and puts the saved setting accordingly to that driver's key. That is the reason your seat keeps moving. You need to reprogram the seat position for that key. Good luck

disconnect negative battery cable.place the ignition lock in the off lock position. remove the 2 switch mounting screws.disconnect the switch from the rod.disconnect the wiring and remove the switch.TO INSTALL.ignition switch installation for non tilt columns.move the the ignition switch slider to the off unlocked position move the slider all the way down.then back 2 clicks.the remote rod hole in the ignition switch slider should now be centered.insert the remote rod in the ignition switch slider hole and install the ignition switch on the steering column.tighten the attaching screws to 35 inch lbs.ignition switch installation for tilt columns.insert the ignition key in the lock cylinder and turn the cylinder to the off unlock position.move the ignition switch downward to eliminate any slack and tighten the attaching screws to 35 inch lbs.

you have a jamed ignition switch replace

Put the brakeon while trying to turn the key, also try turnin the steering wheel, I know it is locked but just put a little pressure on it it should move one way or the other a half inch. If it's standard be sure to put the clutch pedal in as well.