ZH/JT-03 remote for airconditi

There are no codes for A/C units. The are proprietary single frequency units with no published data. You just buy a new one for your unit like this

https://shopee.com.my/%E2%9D%84FUJIAIRE-%E2%9D%84CHIGO-Air-Cond-Aircon-Aircond-Remote-Control-Replacement-%28JT01-JT-03%29-FBS-917RV...-i.3741794.7347963064

https://www.google.com/search?q=fujiaire+fbs-917rb+replacement+remote+control

....

you can remove batteries and let it set 10 minutes or buy an new from amazon $8.00

https://www.youtube.com/watch?v=08h-9I3TwIQ

order an original for your model

remote control not working. First, try replacing the batteries in the remote control. If installing fresh batteries doesn't solve the problem and you can still operate the air conditioner manually, the remote control might be defective.

That is most likely the unit overheating and trying to cool itself off. Check any filters that are on it to be sure they are clean.

Hi there, it's Jack at Dyson.

When you adjust the target temperature of your Dyson Hot fan heater (shown on the LED display on the base), you're setting the target temperature you would like the room heated to. The actual temperature of airflow produced by the fan heater will not vary.

If the heater won't run below 25 degrees, this is likely to be because the temperature of the room you're in is equal to or warmer than 25 degrees. The heater will only turn itself on if the temperature drops below 25 degrees, and once the room temperature reaches this target once again, the fan will turn itself back to monitoring mode.

I've attached our Getting started video below which shows how to adjust the temperature, using the remote or the controls on the base.

I hope this makes sense. It sounds as if your machine is working correctly, but if you'd like any further advice from our experts you can reach us at 0800 298 0298 (UK), 1-866-693-9766 (US), 1-877-397-6622 (CA) or 1800 239 766 (AU).

Raising temperature above 120 degrees requires service call.
Or change dip switch settings and risk voiding warranty and causing service call expense.
http://waterheatertimer.org/Troubleshoot-Rheem-Tankless-water-heater.html#temperature

Earliest versions of Rheem tankless 2006-8 let you set temperature up to 140 degrees F using remote.
However the hotter setting caused error codes because the burner cannot keep up with both high temperature and large volume of hot water rushing through pipe. Especially in winter with cooler incoming water that must be heated more to reach temperature set point.
The burner simply cannot keep up.
So Rheem changed maximum temperature at remote control to tepid 120 degrees, which is not hot enough for folks wanting hot shower, or folks filling whirlpool tub because water in tub cools before tub fills.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

My solution: Buy a universal remote. You can get them at most electronic stores. After finding brand code in booket(usually included with new remote),enter the code then presto!

To reset your prior time setting, remove battery from remote and re set it.Now you can operate as you like.