Question about Philco (R) Classic Turntable CD Shelf System

2 Answers

Philco turntable cd with cassette player all i get is the cassette playing nothing else works where can i get it fixed here in washington state

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 899 Answers

Just find a local electronic repair shop near you
look in the phone book for electronic /electronic repar shop
i have had to repair these before and the selector chip has failed because of a resistor letting to much current and voltage go into the chip , repair cost $40-$50 depending on the dammage

Posted on Oct 29, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Help! My Philco turntable cd with cassette player and radio has a problem I need fixed. The cd tray does not open. What can be done to make this open and close again. Have had it for a couple of years and no problem.

Posted on Jun 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On my Philco Turntable CD with cassette the CD player does not close all the way. If you manually close it, it does not play


You are describing too problems, won't close all the way, could be a bad loadind belt. the second issue it will not play, the timing gear is out of sync, or the laser pickup is not functioning, you will need to take it to a service shop for assessment.

Jun 02, 2012 | Philco (R) Classic Turntable CD Shelf...

1 Answer

Philco turntable belt


See this video. I might help you.

Apr 23, 2012 | Philco (R) Suitcase CD Shelf System

1 Answer

The turntable on my philco cd cassette and turntable unit does not turn. how to i access the belt, etc. to see whats wrong?


I had a similar issue with my Crosley turntable that I recently picked up... and after digging up the manual online all I had to do was lift up on the tone arm and move it to the right (past the holding mechanism) until it clicked, and voila, the turntable started spinning again.

I hope this helps!

Sep 18, 2010 | Philco (R) Classic Turntable CD Shelf...

1 Answer

I have a Philco Classic ... the turntable did not work. I pulled the arm back, as suggested, and it worked! But it really drags when I try to play an LP. What now?


what do you mean it drags? I noticed if you don't pull the arm back far enough,it will turn on,but the arm will drag foward scratching your record. Try pulling it bacl ALL the way and then it should give you no problems.

Sep 29, 2009 | Philco (R) Classic Turntable CD Shelf...

1 Answer

How to turn on turntable on Philco Turntable CD Player


Just pull the arm back a little bit, the turntable should then start.

Apr 20, 2009 | Philco (R) Classic Turntable CD Shelf...

1 Answer

Turntable


hi have a look there will be scrws under a sticker pill the sticker back and you will sea the scrws , and in most caces it will be your balt 1 broken or were and ter sliping cheers

May 25, 2008 | Philco (R) Classic Turntable CD Shelf...

1 Answer

Philco turntable CD with cassette


Most of these are blet driven and the belt is probably slipping. This is a relatively simple repair if you have the correct belt. I'm in Massachusetts, so I don't have any particular recommendations for you. The belt will cost around $10.
Dan

Mar 21, 2008 | Philco (R) Classic Turntable CD Shelf...

1 Answer

Philco Turntable/CD with cassette


Sounds like a classic case of beltitis-most cd players incorporate a small belt attached to a motor and gear on the front of the unit,it either has went bad,bad meaning stretched out or it could be broke in two.Just because its new to you doesnt mean that it didnt sit in a hot warehouse for months before it was put on a retailers shelf.When rubber is subject to heat for long periods of time it breaks down the chemical which keeps elasticity.check that first,if the belt appears or seems to be in decent shape then clean the gear and belt with some isopropyl alcohol,environments like a restaurant which most likely have a lot of grease in the air can slowly built up on the parts inside causing things to slip,might as well spray some wd40 in there,if that isnt the case any of the above then you either have a bad motor ore bad motor ic,ok well good luck and have fun hope you get it going,i just found one in the dumpster that somebody was throwing away because the cd player does not work,good for me im a bench tech,the optic lens assembly is bad,for ten dollars i can replace it with a brand new one to keep this ****** rockin,bye

Jan 08, 2008 | Philco (R) Classic Turntable CD Shelf...

Not finding what you are looking for?
Philco (R) Classic Turntable CD Shelf System Logo

Related Topics:

861 people viewed this question

Ask a Question

Usually answered in minutes!

Top Philco Audio Shelf Systems Experts

 Grubhead
Grubhead

Level 3 Expert

4576 Answers

OSU_Matthew

Level 1 Expert

4 Answers

The Knight
The Knight

Level 3 Expert

68172 Answers

Are you a Philco Audio Shelf System Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...