Craftsman 17.5 hp 42 in. Deck Lawn Tractor - CA Model "turn key tractor nothing" Questions

turn the key and nothing happens, starter does not activate ... nothing. Battery test shows 12.4 volts. Sound like a bad ignition switch? Could be, but test each item with your tester. Test key switch

...Turn key and nothing, no lights on dash, no noises. - Turn Key and weak lights that flicker in start position and clicking noises -Turn key, strong lights but little to no movement from engine or a ...

...key to start the tractor, nothing happens -- engine does not kick over. The needle on tractor's amp meter drops all of the way to the left when the key is turned on. The battery is fine -- I put it ...

...turn the key and nothing. E brake is on. Blade are not inthe on postition. Any help would be great! Herm Check for voltage at the solenoid when the key is in the start position. The wire from the ...

TURN THE KEY NOTHING HAPPENS Hi Tim, When you turn the key, is the brake pedal fully depressed? Is your full weight on the seat? Are the blades disengaged? Are you sure the battery is chargedTry these

running fine. Shut it off for a few minutes. turned the key and nothing Is the small wire, coming from the Ignition Key, Getting 12V to the Relay when you turn the Key? Were Mice chewing on your wires

...key is turned in ignition switch. Turn, turn, turn, then finally the starter turns once. Then nothing. Or it turns and starts. Frustrating. Do I have a bad kill switch? Today I removed the seat and ...

...turn the key and try to start it is as if the battery is out of the tractor no sound nothing. put a volt meter on the battery and it shows voltage. seat has a start sensor in it also. make sure you ...

...tractor that wont start , nothing happens when the key is turned have changed the battrey and still nothing Jumper across the 2 terminals on the starter solenoid with a pair of needle nose pliers and ...

...turn the key, there is nothing. What could be causing this? First see start is good, its on under right dash panel to back of motor. Use a ohm meter, check power to solnoid, show 12v on other side ...