...bar with your fingers it should just half lift out of the guide slot. The chain will loosen a little more as the chain heats up during use. Don't forget to fully tighten up the clamp nuts when ...
...bar and chain. The original Chain and bar are not available. the saw runs good but need the primer bulb and chain bar and chain. Any ideas would be great. Hello Eric, You can get an Oregon brand bar ...
...bar until the chain fits fairly tight, then fit the cleaned cover over the drive. You may have to change the position of the chain adjustment screw a few turns to allow the adjustment 'tang' to drop ...
...bar and the chain still kicks off when I am cutting wood. If you replaced the bar AND the chain, you'll need to make sure the chain is the correct chain for the particular bar you've ...
chain on the bar.(ensure that the chain travels in collation with the sprocket at the end of the bar if equipped). When looking at the saw from the sprocket side(bar to the right) the chain WILL
...getting to the chain. Set the chain so that it doesn't droop from the bar bottom and there should be a lightly oiled joint between the chain and bar. Is there bar oil in the tank? Some specialty bar ...
...bar is usually caused by insufficient oil getting to the chain, but can be caused by the chain being too tight to begin with (you should be able to turn the chain by hand), grit in the chain groove, ...
...bar too. It is somewhat tricky getting the chain on the drive sprocket sometimes but be patient and WEAR LEATHER GLOVES. Put chain on bar first, then chain on sprocket, then bar and chain over studs ...
getting too loose. I tighten down the bar as tight as I can but the chain keeps getting loose. Sagging too far below the bar. I have to tighten it every few minutes. Make sure the bar is positioned on
bar and chain go on this for general crosscut work the bar is determined by the engine capacity small 35 cc engines run 350- 450 mm bar bigger the engine the bigger the bar as for the chain the bigger
215 questions posted
Usually answered in minutes!
311 Questions
93 Questions
31 Questions
30 Questions