Black & Decker 3/8" Variable Speed Reversing Drill Kit" [Misc.] "chuck tight" Questions

...chuck will not stay tight in reverse Chucks ARE meant to stay tight. You also use drill to UNSCREW THINGS. Hi, the Chucks not really meant to stay Tight In reverse. The Idea of the reverse, is to ...

...wrench , L shaped type , with long end out of chuck, small end in chuck. clamp chuck jaws tight around end of wrench. With pipe or hammer, tap end of wrench counter clock wise. These chucks are

...with your right hand. Take the front of the chuck and turn it C CW as seen from the front of the drill. Hold every thing tight and with a little effort or a lot of effort, the chuck should open

...chuck its really tight Some chucks get dirt, grime, and other foreign stuff in them or they rust internally and get stuck.  If it's too tight to get loose by hand you may have to use ...

...in a firm grasp as your hand around a pipe and hold tight,run drill in reverse and that should loosen the chuck and the bit. If its to tight for your hand get a pair of channel locks and hold

...chuck is right threaded but put on very tight.  The best way to losen it is to lock the short leg of a 1/2-inch allen wrench firmly in the chuck so you can hit the long leg with a hammer.  ...

...tight it keeps spinning yeah you have a bad chuck. there is a screw inside the receiver of the chuck if you remove this screw the chuck will come off. Reverse this procedure to re install the new ...

...chuck and tighten it around something like a lag bolt that is firmly secured to something like a bench top, I use the telephone pole outside my garage. After secured tight, give the drill a few raps ...

tight Chuck goes loose in mid drilling causing the bit to slip. Do I need to get a new chuck, drill? If you have a keyed chuck then yes as the jaws are not parallel any more from wear. If keyless then

***** the transmission.  When you put the new chuck on, use a few drops of lok-tite and put it on as tight as you can without breaking the case.  Let the lok-tite set up for at least one day