Bad governor on 6.5 hp Tecumseh engine? I have a 30 year old Toro roto-tiller with a 6.5 hp Tecumseh engine. I finally got it running but it stalls out, even with full throttle. It looks like the ...
Question about Honda Tools & Hardware - Others
are clean . Typically this is a dirt in the carburetor issue. It could also be an improper adjusted governor. If you haven't done anything to affect the governor adjustment, then you have dirt in your
Revs racing on Vanguard twin 18hp After starting up the governor arm shifts in to full revs. It seemed logical that there should be a spring to pull the arm back (to oppose the one that pulls it in). ...
Question about Tecumseh Tools & Hardware - Others
...maybe the first 30 seconds then begins alternately racing and slowing seemingly controlled by the governor, the cycles repeat themselves at a rate of maybe a couple cycles per minute. When a test ...
Question about Tecumseh Tools & Hardware - Others
...and the screw that holds the lever to the linkage oh the block came off hold do you readjust the governor with the trollte wipe opne should the governor be wide open whithout the engine running
Question about Briggs & Stratton Tools & Hardware - Others
...if PTO bearing is going bad and drawing too much amps. First thing u might want to check is the governor--Make sure the spring and linkage is hooked up properly and the governor is moving
Question about Tecumseh Tools & Hardware - Others
...hooked to the wrong place? it's on a maxim tiller 5 hp briggs 130202 3131-01 on a b/s 5hp the small governor spring goes on a thing that has two ears in it.take the tank back off and as you bring it ...
Question about Tecumseh Tools & Hardware - Others
engine reves full out can not controll. It's a 12 hp tecumseh. check that the governor spring is properly attached and that the cable is not stuck
Question about Tecumseh Tools & Hardware - Others
upon starting engine screams then idles down but doesn't have power to run snowblower SOUNDS LIKE YOUR GOVERNOR LINKAGE IS NOT ADJUSTED RIGHT , OR YOUR THROTTLE SHAFT IN THE CARB IS BINDING.
Question about Tools & Hardware - Others
how do i remove the governor out of a tecumseh motor mostly you will have to split the crankcase to do this job.
186 questions posted
Usually answered in minutes!
191 Questions
163 Questions
151 Questions
96 Questions