...generator to repair the engine you must make sure not to damage wiring or brushes. You will need to remove the stator first so remove back cover to expose bolts holding stater to bell. Make note of ...
Question about Briggs Electrical Supplies
...generator, the stator is the non-moving frame or housing. The stator holds the stationary electrical windings. The rotating windings are on the armature or rotor. The rotor is ...
Question about Coleman Electrical Supplies
...generator - 5.5hp honda - can't get the armature off the engine shaft - any special tools needed so i can proceed with tearing down the motor No special tool needed (usually). The armature ...
...GENERATOR. PLEASE EXPLAIN THE FUNCTION OF THIS SETUP. The armature (rotating field) is powered by the voltage regulator for 'excitation' which is the term describing a magnetic, revolving field. This ...
Question about Briggs & Stratton Electrical Supplies
Generator. DO NOT turn the gen. on any more...you might damage the crank or worse.. hold the crank still by pulling the starting handle and tightening it to one of the red bars(the point of this is to
...generator end housing come together. You have to unloosen the center bolt which holds the armature on to the engine. Do not take it out yet just loosen it and whith a block of wood against it hit the ...
...generator/stator housing to frame and carefuflly pull off leaving only armature /rotor on the crank of the engine. Remove the long bolt thru rotor into crank. Now you will need to apply penetrating ...
...generator. i cant get armurature off shaft Assuming that you have removed the stator and the center bolt, (1) apply penetrating oil to space between engine shaft and armature and wait for a few ...
...I probably first look at replacing the stator and rotor? Is this a common part to go out on this generator? check avr / brushes if it has them if not capacitor and diodes on the end of the ...
Question about McCulloch Electrical Supplies
generator The shaft to engine has male tapered end and fits very tightly to armature of gen. Remove stator and remove center bolt thru armature. Place a piece of hardwood aganst metal part of armature
52 questions posted
Usually answered in minutes!
549 Questions
64 Questions
57 Questions
47 Questions