...not turn off!! I could adjust where the air came from, the temp, but it would not shut off!! It came out at full blast too! I turned my car off/on repeatedly to no avail. please help regards richard ...
Question about Hyundai Santa Fe
...HEADLIGHTS STAY ON AFTER TURNING CAR OFF? APPLY HARD PRESSURE DOWN ON TURN SIGNAL AND THEY STAY OFF AS LONG AS YOU HOLD IT, LET GO AND COMES ON, WILL NOT STAY OFF!!! 2002 SANTA FE replace the ...
...over heating so I turned off theair. When I went to turn it on all I got was hot air. i checked the fuse that is not the problem any suggestions TRY CHECKING TO SEE IF YOU NEED TO HAVE AC ...
turn it off immed. it was so rough I turned it off thinking was it the car or and earthquake??? Then when I restarted it it ran smooth again and hasn't shut off until two weeks later. The check engine
...not turn off. I have had it into the dealer 6 times and the problem is still not fixed. They have replaced the passenger seat and the seat belt. Still not fixed. There is a sensor under the seat ...
Question about Hyundai Santa Fe
...car open whenever I turn the engine off. Can this be adjusted? No there is not its the way the automakers had planned it / most vehicles have that feature/Please rate my response Thank you very ...
Question about Hyundai Santa Fe
not at every inch of wheel turn. Sometimes you turn vehicle off with wheel at a point a little off from one of the holes and you just turn wheel a bit and lock will engage. But try starting in neutral
Question about Hyundai Santa Fe
...are off the ground then turn lock to lock-still without motor running-do not let resevoir run out of fluid or it will suck more air in-turning while running will just whip fluid into foam- cheers ...
...not turn off Dear Nazal_Sam,Here are a number of things that can cause YOUR car to not turn off.. fault with the igntion barrel, ignition contacts, electronics. Engine running on, due to incorrect ...
Question about Hyundai Santa Fe
off, or just not cooling well due to fan problem. if its turning off it could be a control head problem or the pcm disabling it for another reason. or if you are manipulating the relay then compressor
1,586 questions posted
Usually answered in minutes!
1,503 Questions
1,043 Questions
881 Questions
417 Questions
235 Questions