1993 Saturn SL2 "inner outer" Questions

...you much. There really is no short cut....you need to replace the half-axle on the right side (will get both inner and outer CV joints). Is driveable with noise, but may eventually fall

...outer end of the cv joint and you should be able to feel the inner snap into place. To make sure that it is reach in and grab the inner axle you should not be able to pull it back out by hand. If you ...

...the harmonic balancer (crankshaft pulley). The outer grooved rim is held to the inner hub with molded rubber. If the rubber fails, the rim can move outward from the engine, causing the

inner wheel well splash shield. If access to the water pump is desired from underhood, remove the air conditioning compressor bolts and position the compressor aside with the refrigerant lines intact.

...inner or outer tie rod. You need to access and remove the jamb nut and boot before you can access the inner tie rod and this is why the outer needs to be removed first. A wheel alignment is advised ...

...inner and outer tie rods on a 2004 Chrysler Pacifica - I waqs told buy a trusted local mechanic that I need to replace 3 of the 4 tie rods. Might as as well replace all 4, but how hard is it to do ...

...outer bearing race and preload spacer. Remove inner oil seal, inner wheel bearing and inner bearing race. NOTE: It is not necessary to remove dust cover (back plate). To Install: Using a suitable ...

...knuckle.Remove the nut and the inner and outer clamps on the tie rod boot.remove the boot.You would then need a special inner tie rod tool to turn the threaded inner rod from the steering

outer tie rod from the inner tie rod. A tie rod removal tool is too big and does not look like it will work. Can I put some degreaser on the screw threads to loosen it up without issues? Yes degreaser

...inner lights are highbeam outer lights low beam and side gaurd lights are your parkers, if you are 100% sure your globes are ok then your dimmer switch is stuffed this is the light switch in the cab ...