Question about Hyundai XG350
...turn the 4 cams by hand toline up marks & crank pulley or keep turnning engine until they get in line Do not remove the old belt until all the marks are lined up. Only then should the old belt be ...
...crank pulley. If it is, the lock key on your crank might have gotten damage due to the pulley that came loose or the vibration damper that is situated between your crank pulley broke loose and the ...
turn over but not crank To clarify, if the engine cranks or turns over but won't start, look for a stuck pulley on the engine. You may be hearing the belt slipping on that pulley. Take
...Turn the crank pulley until the screwdriver moves to TDC. If you see the screwdriver start to go down, you've passed TDC. After you've got the 1st cylinder to TDC, get a permanent marker or paint and ...
Question about Cars & Trucks
...has got to turn. Sometimes the crank pulley has a rubber insert between the balancer and the pulley. If this rubber seperates, the balancer will turn but not the pulley causing the belt not to ...
...the bearing. Also the pulley with the bad bearing will be hard to turn by hand with the belt off. Be sure to check every pulley on that belt circuit, except the crank shaft, you can't turn it by
...turn the crank by hand until i got it right on TDC. I havent tried to start it again after doing all of that yet, but is there anything else i can do? the crank pulley itself wont.. the pulley ...
Question about Hyundai XG350
...still on the engine? You will also need to know if yours is an 'Interference' engine. With an 'Interference' engine the pistons will hit the open valves as you turn the crank stopping it from
...crank shaft is in good condition, and the culprit will turn out to be just a simple loose pulley bolt. The repair cost could catapult to a higher rate if it turns out to be a crank shaft fault. Have ...
Question about Hyundai XG350
crank shaft pulley bolt. Which way does the bolt turn? It turns left (counterclockwise) to remove. An impact wrench is best if you can get one on it. If you don't use an impact wrench, you may need to
175 questions posted
Usually answered in minutes!
265 Questions
270 Questions
89 Questions
11 Questions
4 Questions