...injector pulse and no missfires on #2 and #4, i would suspect clogged injectors. You can have an injector flush performed, which is probably not a bad ideal any way, to see if you can clean them up, ...
...2, &3. I changed the coil, plugs, plug wires. Checked cam sensor and crank sensor with meter, they seem to be fine. Was told by Kia service manger to check timing and it looked fine. So what ...
Question about Kia Rio
...injector pump. I have a 1999 dodge cummins 2500 manual trans 4x4. I haven't driven it for 2 weeks. I put a straight exhaust on it and attempted to start the engine. It turned over a couple of times ...
Question about Cars & Trucks
2 injector s if this is a common rail diesel then the pump will not be producing sufficient pressure to operate the injectors. There will be fuel at the injectors but not the required pressure (20.000
2 oclock position. As the injector lines are hard and bent for each piston then the line from no 1 injector will point to the no1 position on the pump regardless of how many cylinders there are. If it
...2 valves. I replaced the complete head and serviced the pump and replaced new injector nozzles. Also did big ends and small end bushes and new rings. After assembly the vehicle starts immediately and ...
injector pump is fried at this point from cranking with no fuel, the motor should idle, but will stumble all over itself when the throttle is applied. -Brandon There can be 2 problems here. 1. look at
Question about Cars & Trucks
2 marks on the injector pump with the 22 degree mark on the flywheel if the pump is gear driven you will have corresponding timing marks on the idle gear and the crank gear the degrees on the flywheel
...2) If the fuel is reaching the injector pump & not supplying to the injectors nozzles thn the pump needs attention. Hope this helps! Your fuel pump not work.. Did you open pipes to injectors and ...
Question about Jeep Cars & Trucks
...injector (Fig. 19). (2) Crank the engine until all air has been bled from the line. Do not operate the starter motor for longer than 30 seconds. Wait 2 minutes between cranking intervals. (3) Start ...
844 questions posted
Usually answered in minutes!
685 Questions
635 Questions
457 Questions
277 Questions
284 Questions