...spark plugs, then shoot some oil into each spark plug hole. Replace plugs, and try to start. If it still wont try to start, may be out of time. Does it pop, backfire when you are cranking the
Question about Ford Cars & Trucks
...spark plugs and acidently oil whent down in the cylinder what can I do to fix that proble ? Leave plug out and spin the engine over it may start but just turn off. All oil will shoot out put a rag ...
...but wont make full rotation new starter and battery take the plugs out and retry to spin it.. does anything shoot out of the spark plug holes??antifreeze.. oil...may have seized or blown
Question about Cars & Trucks
...ago, if there is no oil on the rings you will have low compression... try squirting some oil in the plug holes, about 5-10 ml... Otherwise check the basics, compression, fuel, spark, timing
Question about Hyundai Accent
replace them. If it was badly flooded you may have to shoot a little oil into the spark plug holes then turn the engine over with the spark plugs out. Reinstall plugs and it should fire off. Good luck
...oil to disappear. if you happen to have a compression gauge take out all of the spark plugs look at the spark plugs if they all look the same or is there ones that look black and sooty(running rich) ...
...spark plug holes.if yes to any of these steps yes bad head gasket. # 4 have a block test done any repair shop can do this. could be the gasket and u need to fix that right away, it might be needed to ...
...spark plugs and shoot in some penetrating oil or good old wd40 into each cylinder before turning the nut with a big breaker barand a length of pipe.let it set for about 2 days. this willlimit scoring ...
...oil in each spark plug hole. Crank it again. Spray a little carb cleaner in each hole and replace the plugs. Pull the distributor cap. Check inside for moisture and use the rag to dry if necessary. ...
Question about Cars & Trucks
...spark plugs... squirt penetrating oil into each cylinder (my opinion)... try to rotate the engine with a wrench on the main-shaft pulley nut (clock-wise of course).
If it rotates you are most ...
1,521 questions posted
Usually answered in minutes!
1,131 Questions
1,047 Questions
517 Questions
500 Questions
255 Questions