...bolt. Remove the water pump pulley, 1.6L (VIN 3) engine only. Remove the power steering pump, 1.6L (VIN 3) engine only. Remove the power steering pump bracket, 1.6L (VIN 3) engine only. Remove the ...
...engine: * The compressor mounting bolts and different lengths, as follows, and must be tightened in A-B-C-D order: Bolt A: 4.96 in. (126mm) long Bolt B: 4.65 in. (118mm) long Bolt C: 4.02 in. (102mm) ...
...it. Is there some trick that i am missing to be able to separate the transmission from the engine? look for a bolt that goes to the trans from the engine, on the back side, hard to find but its ...
Question about Kia Optima
...bolt in. You could even clean it all up and add liquid gasket to be doubly sure of having no leaks. ...
...engine there is a aluminum cover with 2 10mm bolts holding in place under the cover is the crank sensor held in by another 10mm bolt. Remove bolt and remove sensor connector is on a bracket near the ...
...engine to a bolt into the frame behind the engine. I only added a 6 inch wire and a new bolt into the top of the engine. The bolt into the frame was already there, so I just removed it, put the wire ...
...should be located on the left rear of the engine nearest the bell housing. the exciter ring is bolted on the end of the crankshaft inside the crankcase. holp this helps. ...
...under the car. Though , some people doing the engine alone.. would say it is easier (due to rusty bolts under the car etc.) to go thru the top to service the
engine and jacked it up to reposition it. It gave me enough room to get it out. Remove the bottom bolt and disconnect the wiring from it and it should drop out with some effort. Getting it back in was
...bolt out of the water outlet for the lower radiator hose. Pull the thermostat out and install new one. If it has a bleed valve make sure it is pointed up to the twelve o clock position. Reinstall ...
455 questions posted
Usually answered in minutes!
974 Questions
370 Questions
337 Questions
285 Questions
281 Questions