2002 Land Rover Discovery Series II "car sit 30 mins cranks" Questions

...sit overnight it will crank up again and run for awhile before failing agin. I have looked and on the 2000 LR Disco II there is no fuel filter to change. I have swapped the MAS with a known good one ...

car runs for 30 min and then dies ,will run after sitting for 20 min is that the crank position sensor Not the crank sensor. It is the coil. Coils are nothing but a coil of copper wire. When the heat ...

start and stall vehicle will start then shut off after about 30 seconds as if being shut down by theft system then vehicle will crank but not restart unless it sits for a few hours at which time it ...

...sit for 20-30 min then am able to drive it again. While the car is dead I can crank it but will not start and I can drive it at night and it does just fine, its only when it is sunny and hot out that ...

...30 minutes. After letting it sit for 5-10 min it runs fine for another 5-10 minutes, then starts doing it all over again. a bad crank sensor can cause this. shuts off while going down road, and will ...

...key not reading, my key reads 10.55 k Ohms. put 10K resistor across Vat contact under steering column. Engine will not crank & security light stays on solid. turn it off and let it sit for 30 ...

i need to pull the crank shaft pulley what do i use a gear puller? Its best to use a puller, you can borrow a set from autozone. Spray penetrating oil and let sit for 30 mins before using a puller!!

2005 ram 1500 won't start once warm. engine tries to crank, won't fire. Replaced fuel pump recently when it died while driving. Starts fine after sitting for 30 mins. 5.7 hemi

...30 psi steady. Tested the coils they are good. Can let it sit for 10 min will start up and idle 10 15 min and shut off again. Can you help have run out of ideas. Thanks, Jim Hey Jim why havent you ...

...after it sits for 30 min or so it cranks back up and runs for about two weeks or so with no problems use a scanner to check for codes set when problem occurred, if no codes present check fuel ...