1991 Jeep Cherokee Briarwood "ignition change" Questions

...change the ignition switch on a 88 Can find how too change the ignition switch on my 88 Laredo disconnect negative battery cable.place the ignition lock in the off lock position. remove the 2 switch ...

...to iv'e changed my jeep starts only when it wants to iv'e changed Dist. cap,spark plugs and wires,ignition module,rotor,ignition relay,fuel pump,fuel injector s, try and see if the timing is off a ...

...ignition key comes out in any position. I want to change the lock cylinder. Anyone know how? Thanks merlinroad I suggest leaving it alone essentially it's a "so what" problem. If you must, get ...

...the crankshaft position sensor since my tests of the wiring system showed no power between the ignition and battery and i had changed the ignition switch and checked everything else. also i have ...

...grand laredo, missing on acceleration found loose distributer need to set timing. Base (initial) ignition timing is NOT adjustable. Do not attempt to adjust ignition timing by rotating the ...

I HAVE DTC PO351 IGNITION COIL A PRIMARY/SECONDARY CIRCUIT MALFUNCTION. I REPLACED THE IGNITION COIL AND STILL GIVES ME THE SAME CODE. 1 OF THE OLD IGNITION COIL WAS BUBBLED UP AND ALITTLE BURNED. a ...

...is in park. maybe, push up on it while you turn the key. If that don't work, your ignition is broke. There is no way around it. You willhave to change your ignition switch and lock cylinder.

no fire from the ignition module to the distributor ok, i am not getting any spark from my ignition module to the distributor. i had it tested and it is good also i had changed out the crank sensor as

...and coil pack and plug wires plugs, rotor button ,and cap what is the prob? Look to replace ignition module. Ignition modual on the side if the distrbutor is the usual

...still no work.What i can do? If the dealer cut you a key from your vin# and it does not work, the ignition in your vehicle has been changed. There are 2 possible solutions for you, either have a ...