...install a Thermostat on a 1992 Mitsibishi Mighty Max 4cy. Mainly where is it? Thanks follow the top radiator hose to the engine there you will find a housing unbolt this housing and you will find a ...
...system with a 50/50 mix of good quality 5 Year/100,000 mile engine coolant and distilled water. Continue filling radiator until full and install the cap. Fill the coolant reservoir container to the ...
system helps the engine decrease exhaust gases and increase engine power and fuel economy by changing the valve open/close timing of the intake camshaft.The deviation of the camshaft position from the
install cap hand tight and remove again. 3. The cap must be screwed on fully to obtain an accurate fluid level reading. 4. Checking with fluid cold: fluid level must be in area of "MIN" marking, up to
...system airflow is directed. enables blower motor operation. enables auxiliary blower motor operation, if equipped, by supplying voltage to the auxiliary blower motor relay. commands A/C compressor ...
system. The blower motor is off. MAX A/C NOTE: No temperature modulation is possible in the MAX A/C position. In the MAX A/C position, the outside-recirc. air door is in the recirculated air position.
...install them at all. I have notice this time when they went out, was that my van started like it was going to turn off when I turned my heater on then the inside dash lights got real bright and my ...
...Install the lower and upper radiator hoses. Connect the expansion tank hose. Make sure that the overflow hose is clear of the fan and is free of any sharp bends. Fill the cooling system through the ...
...operating temperature. Now slowly fill in the coolant to the specified level until the system is free from air bubbles. Install the cap. Stop the engine and allow it to cool. Remove the cap slowly, ...
328 questions posted
Usually answered in minutes!
495 Questions
353 Questions
191 Questions
166 Questions
75 Questions