2004 Jeep Liberty "butter door" Questions

butter knife and lift it out or pull the door panel off withou damageging the panel.Do not bend the panel anymore than it takes to pop it loose. When you get one out far enough you with see what it is

...butter knife or long flat headed screwdriver in electrical tape. Pry off the door latch bezel (remove screws exposed) Pry off the window roller (if applicable) If you have the tray/storage space on ...

...to take the door panel off I got the screws out but cant get the door panel off how do i get it off? If all screws out, take a butter / putty knife and run along bottom and sides to POP clips

...plastic completely out of the door panel itself because if this happens you will have to figure out a way to repair so the panel will stay on the door get a thin pry bar to this job or a butter ...

...door panel comes pops off with a butter knife or screwdriver etc. and there will be one or two screws in there. Just be as gentle as you can cause sometimes it leaves marks in the plastic. Good

...the doors - fix these broken wires. Another possiblity is the switch in the door itself - these usually will pop out of their socket with a butter knife or similar and can be replaced from

...DOOR OFF. SO ASKING WHERE IS THE LATCH. ONE SUGGESTION WAS TO USE BUTTER KNIFE BUT NEED AN IDEA WHERE THE LATCH IS . There should be manual release cable inside the trunk behind the trim panel near ...

door. then the last one is inder the arm rest get a dull butter knife and slide the knife in the middle of the arm rest between the armrest and door handle. the armrest should slide forward toward the

...off driver side door to put window back on track need more information but most vehicles unscrew handle and or pull handle then a flat butter knife or screw driver carefully pry panel to pop ...

need pages to show how to get into the left rear door liberty 2004. power window has broken linkage to motor. remove all screws and then take a butter knife alnog trim and gently pop it loose