...change, Fuse ? Main Fuse Junction Panel NOTE: The MAIN and ALT fuses are high ampere cartridges that are held in place by screws, which must be removed in order to replace the cartridge. For removal ...
...fan doesn't work or it is on one speed only, it is probably the blower motor resistor. Part is available through Advance for about $30, NAPA has it for $18, takes two days for Advance, one to two ...
...change. If that doesn't work then I would check to see if the wiring from the coolant temp sensor and the fan switch run through the same area of the harness. Its possible that you may have a ...
Question about Mercury Villager
change the fan switch, then the blower if that doesn't work. But changing the switch maybe harder than I invision.... Any suggestions? there is a thing called a blower motor resistor that controls the
fan fuse and relayand switch.You can change relay with another with the same part number to see if that relay is bad.Then check power to and from fan switch if switch has power coming in and not going
Question about Mercury Villager
shows different speed but no change in speed The fan speed reostat is broken or the switch itself is bad. Try replacing the switch first because the motor speed reostat is part of the motor itself. $$
Question about Cars & Trucks
...Fan only blows at high speed. depending on car some have a fan relay or its your switch itself Cause its worn out. The switch is burnt from motor drawing to much juice. When u change switch..chng ...
Question about Cars & Trucks
...fan motor and contol assembly that is attached to the motor, any ideas would be greatly appreciated Yes,could be your blower resistor is bad,it's right next to the blower motor,it controls the blower ...
fan motor run on high speed all time even with control in off mode- it reads switch changes with both the fan control switch on dash or on stearing wheel check the resitor under the dashboard near fan
...power at the switch. If you have power and the fan doesn't run it's the fan motor. If you don't have power change the fuse and try again. If it does run keep an eye on the fan it could be going
569 questions posted
Usually answered in minutes!
478 Questions
326 Questions
276 Questions
247 Questions
178 Questions