Question about Jeep Cars & Trucks
I have a 2001 jeep wrangler sprot. The heater/AC fan switch will work for fan speed 1 through 3 but fan speed doesnt work at fan speed 4 Replace the blower motor resistance it controls the fan speeds.
Question about Audi 90
...fan relay switch because my fan stopped working and jeep overheats when idling or at speeds below 30mph while A/C is on. In my 2005 jeep liberty, the temperature gauge moves to HIGH when idling or ...
...fan speed only works on High On a 2005 Jeep Grand Cherokee, when turning on the heater or air, the fan speed will only work on high. Alot of people have the same problem with the fan switch and blown ...
...fan speed resisitors are broken. This means you will have to replace the fan resistor block. The only other possibility would be the fan switch on the dash you use to set the speed. It is most likely ...
...is on Maximum, but only lowest speed other than that. Recently put new blower fan in. Is problem on switch, rheostat contacts, or module out where fan is installed in firewall? blower motor
...jeep cherokee my fan switch has four settings for speed. it only works on 1 and 4 not on 2 or 3 . is it in the switch or the fan? Switch. i would say the blower resistor is a very strong ...
...models. The fan bypasses the resister on high speed. Therefore the fan should run on HI regardless of resister condition. Suspect the fan control switch or wires connected to it , IF the motor is
on high,if you have power there then replace fan motor,if the fan works on some speeds and not others than check the fan speed control module,it is located in the air duct on pass side below glove box
...speed. how can I fix it? next to the fan motor there should be a connector that has three or four wires that attached to the blower resistor. it should have two screws holding it to heater case, just ...
115 questions posted
Usually answered in minutes!
75 Questions
34 Questions
26 Questions
26 Questions
30 Questions