1999 Jeep Wrangler "change light" Questions

...if the 3ed brake light works , rapidly move hazard switch back & forth & recheck, if they now work change turn signal switch , they are being canceled by switch try changing the brake light ...

...lights on my jeep stopped working at the same time the dash lights went out , all fuses intact, changed the switch to parking and running lights no change , still not working , brake and signal ...

...change the third brake light on a tj How do you change the third brake light on a wrangler 2003 hi you will need a T20 screw driver and then remove the two screws that holds the lens on,then remove ...

...light. It fires back up just fine though. I've changed the fuel filter with no change in symptoms. There are no check engine lights either. This jeeps comes with a factory defect on the electronic ...

...change a rear brake light for my Jeep Wrangler X? there are 4 screws on the rear light. remove the two by the tailgate and the light assymbly will be able to remove by rotating away from the jeep. ...

...change these? An engine light could be on for multiple reasons so I would suggest that you have the fault codes read by a diagnostic computer before you spend more money on components that aren't ...

...light is still on and showing this code. Can anyone help me ? the lamps all change at engine stall , did it stall. at about 300 rpm all engines (gas) stall, and the ECU changes state. all cars. does ...

1998 Cherokee Check engine light Check engine light for 02 sensors, changed both and confirmed wiring good. light still comes on....Help Check the mass airflow sensor, usually if its bad it will ruin ...

Turn signasl do not work, however all lights are ok if they light up but do not flash then change the hazard warning light switch

we had no head lights.. so changed switch.. now we have no brake lights, parking lights and fog lights help Fuse problem, look for a defective fuse, on inside cab, driver side front floor fuse box, ...