1999 Jeep Cherokee "front hub assembly rebuilt" Questions

Ad

Question about Jeep Cherokee

1 Answer

...front hub assembly for a 1999 tahoe, 4x4 be rebuilt, or do you have to replace the whole thing Hi.. On the HUB ASSEMBLE. for your car. You will need to rplace the asemmble. Because is not way to ...

Ad

Question about Jeep Cherokee

1 Answer

...front? Rear brakes can make the pulsation as well. Also if your ABS system is activating that could be described as a "pulsation". The ABS problem is usually caused by a bad wheel speed sensor or ABS ...

Ad

...front wheel bearing repeatedly goes out 1995 Oldsmobile Cutlass Supreme Days after replacing the passenger side wheel bearing, it went out. We took it out to see where we had goofed, but installation ...

...front hub noise is still there. how difficult to replace left cv joint? If you still think the noise is coming from the left side CV joint it would be more advisable to replace the entire axle as an ...

...front tires isn't rubbing on something like the plastic inner fender liner, a mudflap [if installed] or something similar. Another possibility is that you may have a worn outer axle shaft CV joint. ...

Question about Jeep Cherokee

1 Answer

...front right wheel well (sounds like two pieces of metal hitting together), and it speeds up the faster I go. It doesn't do this until I get up over 35mph, but it is extremely loud and sounds ...

Question about Jeep Cherokee

1 Answer

...Front wheel and tire assembly Skid plate, as required. If equipped Drive axle hub nut and washer Brake line and wheel speed sensor support bracket from the upper control arm to allow extra travel of ...

...front driveshaft nuts. Remove the nuts and discard them. Remove the 4 hub retaining bolts. NOTE If the hub is difficult to remove, install 2 long bolt in the bolt holes and strike them to loosen the ...

front wheels , one or both at a time , remove caliper and rotor , remove cotter pin and nut on shaft , there are three or four bolts on back side of hub , remove the hub bearing and shaft should slide

Question about Jeep Cherokee

1 Answer

front axel retaining nut and remove the nut it's a big one 1 3/16 inch and turn it off with your 1/2 inch air impac gun that'll hit at leasest 450 LBs/ Touque. If you don't have this tool take the car

Not finding what you are looking for?
1999 Jeep Cherokee Logo

1,547 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...