2000 Plymouth Neon "control arm" Questions

...control arm. Take a bar, pry down on lower control arm, pulling ball joint out, then pull the upper part out by hand, away from the car, slide axle out of the bearing assembly. Take a pry bar, put ...

control arm from the strut and move the lower arm out the way wit a pry bar on reinstall to make life easyer, also use a hellolot of power lube or wd40 on all bolts n nuts so you dont round any like i

...arm sits. This is the idle control, as it controls how open your throttle is when you are not applying the gas pedal. Tighten this screw a 2-3 turns and try to start your car. You may notice that it ...

...control arm bushings but i still have the same noise.I also changed the sway arm links and bushings.Any ideas? This is to Funny cause i have done all the same things and also changed the struts and ...

WHAT IS THE NAME OF THE BUSHINGS THAT IN THE FRONT THAT COULD CAUSE KNOCKING SOUND control arm bushings

...lower control arm bushings and shafts on a 2004 Dodge Neon? rebuilt shafts about $80 ea.---bushings about $50--(neoprene bushings may cost more--but will last much longer, -installation about

cant remove the bolts from the lower control arms bolt spins but wont come out nut on backside that you cant see???? my jeeps has a hidden nut that is nasty to get to on it Pneumatic 1/2 inch impact ...

...to drop the knuckle, sometimes a control arm too, then pry at the base of the driveshaft to pop it out of the trans casing. Just give it a bit of pressure to overcome the tension of the snap

...you what was bent. Could be lower control arm, spindle, strut, ect. Your caster is way off your going to need to check for previous accident and perhaps they can fix it with a caster adjustment

...THAT GO FROM THE BACK OF THE AXLE TO THE CENTER OF THE CAR. THERE ARE TWO ON EACH SIDE. ARE THEY CONTROL ARMS, SWAY BARS, LATERAL ARMS? THEY ARE IN THE REAR. On my grand am they were called