1988 Jeep Cherokee "crankshaft" Questions

i cannot locate my crankshaft sensor? The standard areas to look would be on the crankshaft pulley, or the flywheel, and occasionally the crankshaft it's self

1994 jeep cherokee turns over but will not start try looking at your crankshaft my jeep just had this problem the mechanic said it was my pmc but in the long run was my crankshaft so i would suggest ...

crankshaft pulley fell off crankshaft pulley fell off get another probley can get one from a junk yard and have it installed and torqued if crank shaft is ok

I have a 96 Jeep Cherokee. Will a bad crankshaft position sensor keep vehicle from starting? Engine cranks fine but will not start. Fuel pressure seems fine, but I don't have spark. the crankshaft ...

crankshaft removal of a 1995 jeep cherokee 2.5td how do i remove a crankshaft from a 2.5td jeep cherokee many thanks steve. To remove crankshaft, engine must be removed from vehicle. It is bolted to ...

...Country wont start.It has spark and Fuel pressure. I have changed the Camshaft position sensor, the crankshaft position sensor, the throttle position sensor, and the pcm. to me it sounds like the ...

...Still waiting for a reman to be delivered. Is this the problem? Most other forums say it's the crankshaft sensor. before you replace the computer have the crank sensor replace it is located ...

replaced camshaft and crankshaft sensor on 1999 jeep cherokee classic, did not make engine light go off, what do i do I replaced camshaft and crankshaft sensors, engine light still on, bought used ecm

...backfires in intake Is there a metallic noise (clanking) when you put it into gear?? You may have a crankshaft sensor or crankshaft wiring that is causing problems. Check to see if there is any wires ...

cranksensor 2007 dodge caliber location Check this location for Crankshaft Position Sensor... Fig. The crankshaft position sensor mounts to the rear of the engine block near the transmission.