2006 Pontiac Vibe "changing tire valve stems without" Questions

...tire valve stem just push and gas should squirt out ... no smoking while doing this ..) if no fuel ... bad fuel pump. if fuel check to see if you are getting a spark by pulling 1 spark plug wire from ...

...valve stems mounted in your factory rims have a tire pressure monitoring sensor/transmitter mounted on the inside. The valve stem itself is the antenna for the transmitter. If you have had the valve ...

...valve stem leaking, tire to rim seal(corroded or damaged), even big changes in temperature can change air pressure in a tire. Best to take it into a good shop and have diagnosed and repaired. Check ...

...tire to correct pressure and drive, light should go off, make sure to have all valve caps off as it gives you a total of 5 mins to complete the program but once key is off you have plenty of time, ...

...valve stem on a tire. If still no gas squirting out, have the person crank the engine while you try releasing pressure again. If still no luck, leave ignition completely on while you listen for ...

...valve stem on a tire, depress the pin inside that fitting and cover with a rag to avoid getting sprayed with fuel while somebody turns the key to on without cranking the motor over! The fuel pump ...

...valve stem on a tire. You remove the cap and screw the gauge on and then turn the key on and read the pressure. I think your Yukon should have about 65PSI of fuel pressure. If your fuel pressure is ...

...Schrader Valve (engine cold) to see if there is any fuel there.. Schrader Valve is onthe fuel rail and looks like a tire valve stem with a black cap.. BE CAREFUL. Gasoline can and will explode ! ! !

...tire air valve. Push the stem and see if fuel squirts out. If not you have a fuel pressure problem and you need to re-check what you did. Fuel pump Filter Shut off switch Plugged fuel line or return ...

...tire). You can get a kit at parts store that will capture the fluid or you can use the shop rags and hold them over the valve while you depress the pin. Honestly, I would get the kit. After my last ...