1990 Ford Bronco II "distributor" Questions

...#1 cylinder plug wire and start the engine-let it warm up, and loosen the hold down bolt under the distributor (1/2")-air the strobe light at the harmonic balancer and gently rotate the loose ...

1988 Ford Bronco II How to change Distributor Pickup Coil Actually, I just need to know how to remove the Distributor Shaft Gear on my 1988 Ford Bronco II 2.9L V6, so that I can change the distributor

how to replace pickup coil in distributor You will need to pull the distributor out and remove the small round pin at the bottom of the drive gear and pull the center shaft out. Need to know on the ...

1988 ford bronco11 have feul,but no fire from distributor to coil no fire from distributor to coil or to plugs, have replaced distributor cap, plugs,tfi module,ignition coil,and fuel filter and still ...

1987 ford bronco 2 turns over wont ignite loose distributor is the any other causes and what happens when distributor loose If your distributor is lose than you need to check the timing. Pull a plug ...

where is the distributor lock down bold located usually right at base of distributor where it seats in the engine, or intake. What engine?

no fire to distributor module, coi, pickup coil and coil o.k. tfi module good Maybe a broken wire going to the distributor, Check that first. Check fuse also ( Engine fuse ). Check distribution box ( ...

where is number 1 on 1984 2.8 ford distributor ? Use the timing marks and put it on Top Dead Center #1 Cylinder and the Rotor in the Distributor will point right at where #1 Plug Wire will go.

...module on a 1989 ford bronco 2 car will spin but not start If it is mounted on the side of the distributor, it takes a special tool to get to the mounting screws. Then there are tabs or pins

...to coil but no spark. has new plugs,cap & wires Remove the tfi module,this is attached to the distributor,have it checked at the auto parts store,if it is bad replace it,if it is good,replace ...