2005 Dodge Neon "reset brake pad light" Questions

Ad

Question about Dodge Neon

1 Answer

...reset it? If the brake light came on it typically is calling out low fluid or the E-brake is on. Check your fluid level and replace with proper fluid. The float may be stuck too causing the light to ...

Ad

...reset the brake pad warning system by turning the ignition switch to the "on" position. As long as continuity to ground exists through all the brake pad wear sensors the system should reset and the ...

Ad

...do you reset it? I just had the brake pads replaced on my 2001 Audi A6 4.2. The "replace brake pad" light is still on. How do I reset the light? Did you change the sensors when you changed the

...reset the brake pad warning light to off but I'm not sure where the BS or reset buttons are to try this procedure. if you didn't replace the brake pad wear sensor, you wont be able to reset ...

...RESET MY BRAKE PAD LIGHT ON 2005 MERCEDES BENZ SL500 TRYING TO RESET BRAKE LIGHT Hi, Typically you cannot "reset" the light. The light illuminates when it becomes grounded, via a small wire pushed ...

Question about Dodge Neon

4 Answers

brake pads are wired to the dash light in a series circut to ground. good ground signal....no light....open circut = dash light. After extentive testing i found a broken wire inside the harness at the

reset it? I just had the brake pads replaced on my 2001 Audi A6 4.2. The "replace brake pad" light is still on. How do I reset the light? you need to replace the pad wear sensor when the pad

...reset? If you're talking about brake pads that have an electrical connector.. the warning light comes on when the pad is so worn that it allows the electrical connector to earth via the disk .. hence ...

Question about Dodge Neon

3 Answers

reset, then the brake sensor was damage. You will need to replace the brake sensor. It sounds like you replace the brake right after you saw the warning, so the brake sensor should be okay. There is a

...reset brake pad warning indicator light after servicing brakes. disconnect + battery terminal and start car then pump brakes till light goes out then test you have to replace the brake pads, and make ...

Not finding what you are looking for?
2005 Dodge Neon Logo

1,099 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2002 Dodge Neon
2002 Dodge Neon

861 Questions

2004 Dodge Neon
2004 Dodge Neon

762 Questions

2003 Dodge Neon
2003 Dodge Neon

743 Questions

2000 Dodge Neon
2000 Dodge Neon

606 Questions

2001 Dodge Neon
2001 Dodge Neon

544 Questions

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...