Question about Ford Ranger
wheel bearings on a 2013 px 4wd ford ranger - also how do I change them???? I like to do as much work on the vehicle as I can but not sure if these bearings are self lubricating or not and I dont have
How do I change the front passenger CV joint? Easiest approach is to change entire axle. Depends on car, but generally remove wheel, remove axle nut, loosen lower ball joint and separate wheel assy ...
...Wheel Bearings - REMOVAL & INSTALLATION (see Figure 1 ) Fig. 1: Inspect the bearings for abnormal wear and/or damage With Manual Locking Hubs (see Figures 2 through 17) Raise the vehicle and ...
Question about Ford Ranger
...your foot off the gas pedal its not the front wheel hub assembly as they were changed recently thought it might have to do with the drive shaft.... possible bearings Sounds like wheel bearings to
...treads). Wiggle each wheel to look for loose wheel bearings--may have damaged bearings. A bent brake rotor is also a possibility. Good luck! I have the same issure but I just replaced the
left front weel makes loud noise, I did replace brak pads but look that something else is not working right, may it be bearing? Wheel bearing noise can be identified as a growl type noise at highway ...
...intensity when cornering; but again, not hugely loud. Just this rumble. Good garage; do not want to change parts unless sure. Not pleasant to drive now on long journeys. Please help. wheel
...it stops, i cant figure it out Jack the front of the car up then spin the wheels this will give you alot better idea of where this noise is coming from. Check the brakes agian and the wheel
wheel bearings etc. In order to replace the front rotors, you first jack the front end up to lift the wheel off the ground and put a jackstand to support the vehicle and put a block on the rear wheels
927 questions posted
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
558 Questions
477 Questions